User manual UFREE SCOOTER SCOOTER ELETTRICO FS-E11

[. . . ] 1. 1. 2 To ensure this scooter to have a long life, please read the manual instructions before your operation to this scooter. Don't lend it to the people who can't operate this scooter correctly. 1. 1. 3 Since the speed is fast, please be careful to use it in the snow or rain weather, have a brake in advance when braking is necessary. [. . . ] 1. 3. 5 Before storage, please charge the scooter fully; also suggest to charge the scooter per month. 1. 4 Caution: 1. 4. 1 When riding on the smooth road at low windy speed, under the safety condition, should not stop and start the scooter frequently. 1. 4. 2 To ensure the battery to be in good condition, please charge it in time after your riding. Frame and instruction 2. 1 This scooter is equipped with the battery of high power and lead-acid free of maintenance. The battery is located in the best place, make the gravity point low, and insure the balance & safety to the rider. 2. 2 This scooter is equipped with the electric driving control non-grade HUOER accelerator system, which can protect the motor and battery effectively and have a safety operation. 2 UFREE SCOOTER www. scooter-manufacturer. com 2. 3 One special full automatic charger is used to this scooter, which can avoid overcharge. Main technical parameter and function index 3. 1 Entire scooter specification: Max speed: 12. 5 miles/hour Range per charge: 10 miles Max load: 200 lbs Incline capacity: approx. 4° Net weight including battery: 45 lbs Tyre: 12" pneumatic 3. 2 Motor parameter: Rated power: 250W-350W Rated volt: 24V 3. 3 Battery: Type: high power lead-acid storage battery free of maintenance Current: 12AH Voltage: 12Vx2 3. 4 Charger: Input volt: 110-220V Charge time: 6-8H 4. 4. 1 Assemble and adjust method Assemble 4. 1. 1 Take out the scooter from the carton. (Figure 1) 4. 1. 2 Loose the flat bolt in the handle bar, remove the pin and insert the connector to handle bar, then insert the pin shaft, tighten the bolt, turn and tighten the folding unit to steady the handle. (Figure 2) 3 UFREE SCOOTER www. scooter-manufacturer. com Assemble the handle bar, put the accelerator correct location, fix it with hex spanner. (Figure 4) 4. 3 Adjust the rear brake 4. 3. 1 Adjust the rear adjusting bolt, tighten the brake bar to insure rear wheel not turning, loose the brake bar, rear wheel turning freely. (Figure 5) 4. 3. 2 If brake shoe (brake rubber) wear-tear too much, please replace it in time. 4. 4. 1 Loose the front shaft nut, remove the special washer to the hole (O6. 5), tighten front shaft nut, insure the front wheel in correct location. [. . . ] Chart 1 term inspection and maintenance 300miles 600miles 1200miles 1800mile Brake A I A I Different control L I L I Tyre I I I I All the connect lines I I T I Front fork and frame I I I I Note: I-inspection, clean and adjust T: tighten A: adjust L: lubricate 5 UFREE SCOOTER www. scooter-manufacturer. com 6. Troubleshooting Please see the chart 2. Chart 2: troubleshooting Numb Troubles Reason 1 The speed control 1. Many ascents, low heavy wind, the road surface isn't weight is over 200 Over many brake 4 The charger can't be 1. Start the electric charging state of the see if the battery and the electric than 20. 5V; can't start. [. . . ]