User manual TYAN S8225-S8225AGM4NRF

[. . . ] Sony/Philips Digital Interface (SPDIF) is a trademark of Sony Corporation and Philips Electronics. Portable Document Format (PDF) is a trademark of Adobe Corporation. Information contained in this document is furnished by TYAN Computer Corporation and has been reviewed for accuracy and reliability prior to printing. TYAN assumes no liability whatsoever, and disclaims any express or implied warranty, relating to sale and/or use of TYAN products including liability or warranties relating to fitness for a particular purpose or merchantability. TYAN retains the right to make changes to product descriptions and/or specifications at any time, without notice. [. . . ] Enabled / Disabled Onboard RAID IDE Device: (Optional) This item is optional function. It allows you to decide to "Enable" or "Disable" the onboard RAID IDE device. Enabled / Disabled Onboard SATA IDE Device: (Optional) This item is optional function. It allows you to decide to "Enable" or "Disable" the onboard SATA (Serial ATA) device. Enabled / Disabled 3-16 http://www. tyan. com Trinity KT400 S2495 Super IO Device: Phoenix ­ AwardBIOS CMOS Setup Utility Super IO Device Onboard FDC Controller Onboard Serial Port 1 Onboard Serial Port 2 UART Mode Select RxD, TxD Active IR Transmission Delay UR2 Duplex Mode Use IR Pins Onboard Parallel Port Parallel Port Mode EPP Mode Select ECP Mode Use DMA Game Port Address Midi Port Address X Midi Port IRQ [Enabled] [3F8 / IRQ4] [2F8 / IRQ3] [Normal] [Hi, Lo] [Enabled] [Half] [IR-Rx2Tx2] [378 / IRQ7] [SPP] [EPP1. 7] [3] [201] [Disabled] 10 Chapter 3: BIOS Setup Item Help _________________________ Menu Level ?? : Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults Onboard FDC Controller: Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and you wish to use it. If you install and-in FDC or the system has no floppy drive, select "Disabled" in the field. Enabled / Disabled Onboard Serial Port 1 / 2: Select an address and corresponding interrupt for the first and second serial ports. 3F8/IRQ4 / 2E8/IRQ3 / 3E8/IRQ4 / 2F8/IRQ3 / Disabled / Auto UART Mode Select: This field allows the users to configure what IR mode the 2nd serial port should use. Normal / IrDA and ASKIR RxD, TxD Active: This field configures the receive and transmit signals generated from the IR port. Hi, Hi / Hi, Lo / Lo, Hi / Lo, Lo IR Transmission Delay: This item allows you to "Enabled" or Disabled" the IR transmission delay. When Select Password, Please press ENTER key to change Password Max 8 numbers. : Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults PS2KB Wakeup Select: This item allows you to select Hot Key or Password to wake-up the system by PS2 Keyboard. When select Password, please press "ENTER" key to change password max 8 numbers. 3-20 http://www. tyan. com Trinity KT400 S2495 Chapter 3: BIOS Setup PS2KB / MS Wakeup from S3/S4/S5: This item allows you to set a Hot Key to wake-up the system by PS2 Keyboard. Disabled / Ctrl+F1 / Ctrl+F2 / Ctrl+F3 / Ctrl+F4 / Ctrl+F5 / Ctrl+F6 / Ctrl+F7 / Ctrl+F8 / Ctrl+F9 / Ctrl+F10 / Ctrl+F11 / Ctrl+F12 / Power / Wake / Any Key Note: Power and Wake are the Windows98 Keyboard button. VGA: When set to "On", any event occurring at a VGA port will awaken a system, which has been powered down. On / Off LPT & COM: When set to "LPT/COM any event occurring at a COM (serial) / LPT (printer) port will awaken ", a system, which has been powered down. LPT/COM HDD & FDD: When set to "On", any event occurring at a hard or floppy drive port will awaken a system, which has been powered down. On / Off PCI Master: When set to "Off", any event occurring to the DMA controller will awaken a system, which has been powered down. On / Off PowerOn by PCI Card: An input signal from PME on the PCI card awakens the system from a soft off state. Enabled / Disabled Wake Up On LAN / Ring: Defines whether the system will wake up if the modem is dialed into. Enabled / Disabled RTC Alarm Resume: Defines the time / date when the system will wake up. Enabled / Disabled 3-21 http://www. tyan. com Trinity KT400 S2495 IRQs Activity Monitoring: Phoenix ­ AwardBIOS CMOS Setup Utility IRQs Activity Monitoring Primary INTR IRQ3 (COM 2) IRQ4 (COM 1) IRQ5 (LPT 2) IRQ6 (Floppy Disk) IRQ7 (LPT 1) IRQ8 (RTC Alarm) IRQ9 (IRQ2 Redir) IRQ10 (Reserved) IRQ11 (Reserved) IRQ12 (PS/2 Mouse) IRQ13 (Coprocessor) IRQ14 (Hard Disk) IRQ15 (Reserved) [On] [Enabled] [Enabled] [Enabled] [Enabled] [Enabled] [Enabled] [Enabled] [Enabled] [Enabled] [Enabled] [Enabled] [Enabled] [Enabled] Chapter 3: BIOS Setup Item Help _________________________ Menu Level ? [. . . ] Auto assign ports to onboard COM ports if the corresponding item in Setup is set to "AUTO". Reserved Reserved Reserved Reserved Reserved Detect & install all IDE devices: HDD, LS120, ZIP, CDROM. . . (Optional Feature) Enter AWDFLASH. EXE if: -AWDFLASH. EXE is found in floppy drive. Reserved 5-12 http://www. tyan. com 6Eh: 6Fh: 70h: 71h: 72h: 73h: 74h: 75h: 76h: 77h: 78h: Trinity KT400 S2495 POST (hex) 79h: 7Ah: 7Bh: 7Ch: 7Dh: 7Eh: 7Fh: Reserved Detect & install co-processor Reserved Init HDD write protect. [. . . ]