User manual TRIMBLE SNM910 CELLULAR MODEM QUICK REFERENCE CARD

[. . . ] ­ When inserting or removing a SIM card, ensure that the modem is in a dust-free indoor environment. ­ The SNM910 modem must not be connected to power when you insert the SIM card. Before inserting the SIM card, turn off the host, disconnect the power cable and then remove the modem from the bracket. Insert the SIM card in the direction shown by the arrow on the casing: 4. Replace the SIM slot cover and then tighten it securely. Attaching the bracket The mounting bracket is required to hold the SNM910 modem in place and allows you to mount the combined unit correctly. [. . . ] Wrong PIN Need PIN Need PUK No SIM ISP Connected ISP in progress ISP Failed Start Bad Base or MP Bad Credentials Data Unavailable Bad Server URL Receiving data Sending data to view the modem status. You have entered an incorrect CPIN 3 times; enter the 8-digit PUK supplied by the Service Provider. Internet connection is in progress The SNM910 could not connect to the ISP. IBS Base sending correction data to IBSS. Using the front panel to control an IBSS field base panel Once the IBSS Field Base has been configured, it can been turned on and turned off from the front panel: 1. From the home screen, press L J L in turn, and then press J or K to select either: ­ Connect ­ Disconnect ­ Reset Note: To view the GPRS Signal strength (RSSI) on the SNM910 status you need to use the Disconnect command. When you are in a location with good signal then use the Connect command to start the connection. Press L to activate the command. 4 IBSS 900 MHz Rebroadcaster setup Trimble recommends that you configure the SNB900 radio as a Rebroadcaster in the office before mobilisation. Connect adapter P/N 57158 to the 26-pin connector on the modem and then connect the power cable to the adapter. Use an Ethernet cable to connect a laptop running the Windows® operating system to the adapter and then turn on both the SNM910 modem and the SNB900 radio. Note: The laptop must not have any existing wireless or wired ethernet connections. Press n to navigate to the Protocol screen and then press K to select Easy IP. After the modem has saved and rebooted, press n to navigate to the Mode screen and then press K to select Rebroadcaster. Press J to navigate to the Ethernet Addr screen and make a note of the IP address (normally 169. 254. 2. 1). Open a browser application (for example, Mozilla Firefox or the Internet Explorer® internet browser) and then enter the IP address into the address field. Open the SNM910 Modem page and then click Configure to set the APN, CID, user name, and password provided by your Internet Service Provider. Open the IBSS/NTRIP Client page, set the Mode to IBSS, enter the TCC Org, TCC Password, and Base Name and then click Save Changes. Note: Base Org is required only if the Base belongs to a different TCC Organisation. Open the Configure wireless page, set the Network number and Easy IP name for the 900 MHz radio and then click apply Settings. [. . . ] Lost ISP connection, will re-establish NTRIP/IBSS when reconnected to ISP. "Data" may be replaced by the correction type, for example, CMR. © 2010. Trimble and the Globe & Triangle logo are trademarks of Trimble Navigation Limited, registered in the United States and in other countries. Microsoft, Windows, and Intenet Explorer are registered trademarks of Microsoft Corporation in the United States and/or other countries. [. . . ]