User manual TRIMBLE S8 TOTAL STATION FIRMWARE R12.1.6 RELEASE NOTES

[. . . ] Trimble S8 Total Station Firmware R12. 1. 6 Release Notes Trimble S8 Total Station Firmware R12. 1. 6 Release Notes Note: Please refer to the Trimble® S8TM Total Station User Manual for legal information. Introduction These release notes contain information about the Trimble S8 Total Station firmware version R12. 1. 6. In a newly purchased instrument, Trimble S8 Total Station firmware version R12. 1. 6 should already be installed from the factory. [. . . ] Ensure that the Trimble CU / Trimble TSC2 controller is removed and that you have a fully charged battery in the instrument. Run the file Trimble S8 Total Station Firmware R12. 1. 6. exe that you saved on the office computer to begin the firmware upgrade. Follow the instructions in the installation wizard to complete the upgrade. Using the Trimble S8 Total Station with other Trimble Products Trimble S8 Total Station firmware version R12. 1. 6 is compatible with the following Trimble survey field software. Page 1 of 2 Trimble S8 Total Station Firmware R12. 1. 6 Release Notes Trimble Access 1. 4. 0 and later on the Trimble CU and Trimble TSC2. Trimble® Survey ControllerTM software version 12. 20 or later on the Trimble CU and Trimble TSC2. Trimble® Survey ManagerTM software Field and Tablet PC version 2. 51 or later. Please check the release notes for the respective Trimble survey field software for more specific product information including operating system and Trimble office software requirements. IMPORTANT: This version of Trimble S8 Total Station firmware is not compatible with versions of Trimble survey field software older than those listed above. Please take note of the following information before upgrading your Trimble S8 Total Station. If you have a new instrument that was delivered with firmware version R12. 1. 6 already installed, please note that any controller that will be used with the new instrument is required to run the respective Trimble survey field software version listed above or later. Controllers delivered at the same time as a new instrument will already have the latest versions installed. Older controllers that you already own might need to be upgraded to their latest versions. Note that this will require a valid software warranty agreement for the Trimble survey field software. [. . . ] This firmware version supports newly released models of the Trimble S8 Total Station with Trimble VISIONTM technology. The new instrument models are listed below. S8023100 S8023200 S8023300 S8123100 S8123200 S8123300 Trimble S8 0. 5" Autolock, DR HP, Trimble Vision, FineLock Trimble S8 0. 5'' Robotic (Global), DR HP, Trimble Vision, FineLock Trimble S8 0. 5'' Robotic (French), DR HP, Trimble Vision, FineLock Trimble S8 1" Autolock, DR HP, Trimble Vision, FineLock Trimble S8 1'' Robotic (Global), DR HP, Trimble Vision, FineLock Trimble S8 1'' Robotic (French), DR HP, Trimble Vision, FineLock · Support for new revisions of internal printed circuit boards. Page 2 of 2 [. . . ]