User manual TRIMBLE NOMAD X GETTING STARTED GUIDE

[. . . ] 7 Browsing the Internet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Internet Sharing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 SMS messages. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Using contacts to send a message. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Also ensure that the notched corner aligns with the angled corner on the SIM carriage. Close the SIM carriage and then slide it to the locked position (to the left). Place the battery door over the battery, with the flat side of the battery door at the top of the unit. Use the screwdriver end of the stylus or screwdriver to gently tighten the four screws. Turn the unit ON to resume operation. 3 Customizing your phone Tap Start / Settings / Phone. The following settings are described below. Phone Number The ring for text messaging notifications can be changed. Tap Start / Settings / Sounds & Notifications / Notifications and select Messaging: New text message. PIN Number: a PIN can be set to block unauthorized access to your data connection. NOTE: This device is data-only and dialing controls are not available. Call Forwarding: Voice calls to the Nomad can be forwarded to another phone. Because the Nomad is a data-only device, most of these settings do not apply. 4 IMEI: Unique number that identifies the phone module that is embedded in the Nomad. NOTE: If you purchase a SIM card separately, the phone service provider may want your Nomad IMEI number. It is located on this screen, as well as in the battery compartment. NOTE: Leave settings set to Auto Band Select unless there is a good reason to make these adjustments manually. 5 GPRS Connection Setting up the GPRS connection 1. To make connections easier in the future, type in a new connection name, such as the name of your service provider. Enter the access point name if provided by your service provider, and tap Next. Enter the credentials provided by your service provider and tap Finish. (User Name and Password may be required by your Service Provider. ) Starting a GPRS connection Tap on the Wireless Manager on the Today screen to turn on the phone. If you want to start the connection manually, tap Start / Settings / Connections tab / Connections. E or G will automatically appear in the notification bar and will on depend upon the network capabilities in that area. Some service providers may only provide GPRS. 6 Using the WWAN features NOTE: The Wireless WAN (wide area network) features of this Nomad are used only for data communication and do NOT have voice capability or the ability to send MMS messages (Multimedia Messaging Service). Voicemails left on this number can be retrieved only by using another phone, depending upon the plan you purchased from your service provider. It is recommended to request the data-only plan from your service provider and have a "voice restriction" placed on your line. Use the Wireless Manager to turn on the phone and wait at least 30 seconds before using the phone. [. . . ] Select limit network visibility and only the ones listed can be used and other networks will not be visible. This feature is a convenience to keep other wireless networks from alerting your unit. If you want to add other wireless networks, change this setting. Features not available This Nomad does NOT have voice capability or the ability to send MMS messages (Multimedia Messaging Service). Voicemails sent to the Nomad can be retrieved only by using another phone, depending upon the plan you purchased from your service provider. 10 Other Nomad resources This manual covers only the Wireless WAN part of your Nomad. [. . . ]