User manual TRIMBLE HR150

[. . . ] LEDs (front and back)-- show the position of the receiver relative to the laser beam (high, on-grade, or low), and indicate power and low-battery status. Clamp-Tab Recess--is the area that the general-purpose clamp's release tab fits into. 9 HR150 Receiver · User Guide Thank you for choosing the Spectra Precision® Laser Receiver HR150 from the Trimble® family of precision instruments. [. . . ] Note: If the audio function is on, the receiver beeps quickly when the receiver is above the laser beam, slowly when below it, and continuously when centered in the laser beam or on grade. Note: The top/bottom red LEDs flash when the receiver is above or below the laser beam. The green LED flashes when the receiver is on grade. LED/Audio Information LED/Audio Indication Function Green LED: flashes once every two seconds Top red LED: flashing Green LED: flashing Bottom red LED: flashing Both red LEDs: flashing in sequence Receiver is on High On-grade Low Low battery Audio on Beam location Audio Output N/A Fast beeping tone Continuous tone Slow beeping tone N/A 3 beeps Single beep High On Grade Low Power/Audio Button Audio Port Low Battery Speaker beep 1. Release the battery door using your fingers, a coin, or a screwdriver. Install/Remove the 2 AA batteries noting the positive (+) and negative (­) diagram on the bottom of the battery housing. Close the battery door and latch it shut. ­5­ ­6­ ­7­ ­8­ General-Purpose Clamp The C61 general-purpose clamp allows the receiver to be attached to a survey rod or wooden pole. Features and Functions 1 2 3 4 Attaching the Receiver to the Survey Rod or Wooden Pole 1. Slide the general purpose clamp into the receiver until it "clicks" into position. Turn the jaws screw clockwise to hold the general-purpose clamp securely in place. Receiver Specifications LED Channels Capture Height Acceptance Angle On-Grade Sensitivity Power Source Low Battery Indicator Automatic Shutoff Spectral Sensitivity 3 50 mm (2 in. ) 90° Medium: 3. 00 mm (1/8 in. ) Two 1. 5-V batteries (type LR6/AA) Red LEDs flash in sequence 30 minutes after last laser detection or push-button actuation Operates with red visible and infrared rotating lasers with wavelength between 610 and 900 nm 50 mm (2 in. ) below top of receiver, on both sides ­20 °C to +50 °C (­4 °F to +122 °F) ­40 °C to +70 °C (­40 °F to +158 °F) 0. 3 kg (. 75 lb) 13. 6 x 5. 0 x 2. 8 cm (5. 37 x 2. 00 x 1. 11 in. ) ­ 11 ­ Notice to Our European Union Customers For product recycling instructions and more information, please go to: www. trimble. com/environment/summary. html Recycling in Europe To recycle Trimble WEEE, call: +31 497 53 2430, and ask for the "WEEE associate, " or mail a request for recycling instructions to: Trimble Europe BV c/o Menlo Worldwide Logistics Meerheide 45 5521 DZ Eersel, NL Battery Life @ 20 °C (68 °F) Alkaline: 70+ hours 5 Marking Notch 1. Release Tab--allows the receiver to be locked onto or released from the general-purpose clamp. Jaws--close/open so that the general-purpose clamp can be attached to or released from a survey rod or wooden pole. Reading Edge--aligns with the receiver's on-grade marking notches. Circular Bubble Screw Holes--are where the optional 1277-6251S grade rod circular bubble kit is mounted. ­9­ ­ 10 ­ Operating Temperature Storage Temperature Weight Dimensions (H x W x D) ­ 12 ­ EMC Declaration of Conformity This receiver has been tested and found to comply with the limits for a Class B digital device for radio noise for digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communication, and is pursuant to part 15 of the Federal Communication Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. If it's not used in accordance with the instructions, it may cause harmful interference to radio or television reception. Such interference can be determined by turning the receiver off and on. [. . . ] The foregoing states the entire liability of Trimble regarding the purchase and use of its equipment. Trimble will not be held responsible for any consequential loss or damage of any kind. This warranty is in lieu of all other warranties, except as set forth above, including any implied warranty merchantability of fitness for a particular purpose, are hereby disclaimed. [. . . ]