User manual TRIMBLE AGGPS EZ-GUIDE SL SUPPORT NOTE

[. . . ] Verify that power is available at the cable connection to the lightbar (round connector with two large wire leads). Clasp you hands over the keypad and verify the keypad's backlight is lit. The cables are not connected correctly or are faulty. Check that the cabling is connected correctly, and that the power source is on. If you have two cables (PN 40947 and PN 35204), only one of the two cables should be attached to power. [. . . ] In technical terms, the HDOP is too high (more than 3. 0). Move away from trees or buildings into a more open setting with more sky visible. Any major obstructions within 15° of the horizon may be blocking a key satellite. Wait for up to half an hour for more satellites to come into view. Trimble Navigation Limited Agriculture Business Unit 9290 Bond Street, Suite 102 Overland Park, KS 66214 U. S. A. Trimble, and AgGPS are trademarks of Trimble Navigation Limited, registered in the United States Patent & Trademark Office. The Globe & Triangle logo, and EZ-Guide are trademarks of Trimble Navigation Limited. Page 2 of 5 AgGPS EZ-GuideTM SL ® Agriculture Problem Possible cause/s Solution/s The lightbar displays NO HOST or NO COMMS and will not provide guidance. The lightbar and AgGPS 110 are not communicating properly. Wait for about one minute to see if the problem resolves itself. Ensure that Port B is outputting LBAR protocol at 38. 4K 8-N-1, and that the correct serial port is connected to the lightbar. Each connector on the cable is labeled with a white tag that shows where it should be attached. Try swapping out items such as the cable, the smart antenna, and the lightbar, to identify any faulty equipment. The lightbar displays the message INV GPS. The receiver is not outputting the right messages. Ensure that Port B is outputting LBAR protocol at 38. 4K 8-N-1, and that the correct serial port is connected to the lightbar. If you have two cables (PN 40947 and PN 35204), make sure that they are connected together according to the diagram in the EZ-Guide Quick Reference. The lightbar says MAX PTS when I try to add an area point. You are trying to add too many points. EZGuide can store a maximum of 99 area points when defining an area or custom endzone boundary. The alarm is not connected correctly. Clear the area and define it again, adding fewer points. The alarm does not sound when I expect it to. Trimble Navigation Limited Agriculture Business Unit 9290 Bond Street, Suite 102 Overland Park, KS 66214 U. S. A. www. trimble. com Verify that the alarm is connected correctly to the lightbar cable (PN 46441or PN 35204). The alarm connects to the black and white cable pair that extends from the end marked "TO AgGPS RECEIVER". This cable pair may be terminated by a small rubber cap, which should be removed. Connect the white cable to the + terminal and the black cable to the ­ terminal on the alarm. © 2003, Trimble Navigation Limited. Trimble, and AgGPS are trademarks of Trimble Navigation Limited, registered in the United States Patent & Trademark Office. The Globe & Triangle logo, and EZ-Guide are trademarks of Trimble Navigation Limited. [. . . ] The Globe & Triangle logo, and EZ-Guide are trademarks of Trimble Navigation Limited. Page 4 of 5 AgGPS EZ-GuideTM SL ® Agriculture Problem Possible cause/s Solution/s The alarm and approach LED does not respond at endzone boundaries. By default, the orange warning approach LED is not displayed when HLNDWARN=0. This is the default. Increase the value of HLNDWARN to a value greater than 0. Trimble Navigation Limited Agriculture Business Unit 9290 Bond Street, Suite 102 Overland Park, KS 66214 U. S. A. [. . . ]