User manual TRIMBLE AGGPS 262 2.00 RELEASE NOTES REV A

[. . . ] Trimble, the Globe & Triangle logo, and AgGPS are trademarks of Trimble Navigation Limited, registered in the United States and in other countries. Release Notice This is the September 2009 release (Revision A) of the AgGPS 262 Receiver Firmware Version 2. 00 Release Notes. . It applies to version 2. 00 of the AgGPS 262 receiver firmware. LIMITED WARRANTY TERMS AND CONDITIONS Product Software Product software, whether built into hardware circuitry as firmware, provided as a standalone computer software product, embedded in flash memory, or stored on magnetic or other media, is licensed solely for use with or as an integral part of the Product and is not sold. If accompanied by a separate end user license agreement ("EULA"), use of any such software will be subject to the terms of such end user license agreement (including any differing limited warranty terms, exclusions, and limitations), which shall control over the terms and conditions set forth in this limited warranty. [. . . ] Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Responsible Party: Trimble Navigation Limited 935 Stewart Drive Sunnyvale CA 94085 Telephone: 1-408 481 8000 Industry Canada Compliance Statement This Class A digital apparatus meets the requirements of the Canadian Interference-Causing Equipment Regulations. Avis de conformité à la réglementation d'Industrie Canada. Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada. European Community Compliance Statement This product is in conformity with the protection requirements of EU Council Directive 89/336/EEC on the approximation of the laws of the Member States relating to electromagnetic compatibility. TRIMBLE cannot accept responsibility for any failure to satisfy the protection requirements resulting from a non-recommended modification of the product, including the fitting of nonTRIMBLE option cards. Australia and New Zealand Class A Statement Attention: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate Official Language THE OFFICIAL LANGUAGE OF THESE TERMS AND CONDITIONS IS ENGLISH. IN THE EVENT OF A CONFLICT BETWEEN ENGLISH AND OTHER LANGUAGE VERSIONS, THE ENGLISH LANGUAGE SHALL CONTROL. measures. Australia and New Zealand This product conforms with the regulatory requirements of the Australian Communications Authority (ACA) EMC framework, thus satisfying the requirements for C-Tick Marking and sale within Australia and New Zealand. Notice to Our European Union Customers For product recycling instructions and more information, please go to www. trimble. com/ev. shtml. Recycling in Europe: To recycle Trimble WEEE (Waste Electrical and Electronic Equipment, products that run on electrical power. ), Call +31 497 53 24 30, and ask for the "WEEE Associate". Or, mail a request for recycling instructions to: Trimble Europe BV c/o Menlo Worldwide Logistics Meerheide 45 5521 DZ Eersel, NL Registration To receive information regarding updates and new products, please contact your local Trimble authorized dealer or visit the Trimble website at www. trimble. com/register. Upon registration you may select the newsletter, upgrade, or new product information you desire. Notices This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense. Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. TRIMBLE is not responsible for any radio or television interference caused by using other than recommended cables and connectors or AgGPS 262 Receiver Firmware Version 2. 00 Release Notes 3 Restriction of Use of Certain Hazardous Substances in Electrical and Electronic Equipment (RoHS) This Trimble product complies in all material respects with DIRECTIVE 2002/95/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 27 January 2003 on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS Directive) and Amendment 2005/618/EC filed under C(2005) 3143, with exemptions for lead in solder pursuant to Paragraph 7 of the Annex to the RoHS Directive applied. Declaration of Conformity We, Trimble Navigation Limited, 935 Stewart Drive PO Box 3642 Sunnyvale, CA 94088-3642 United States +1-408-481-8000 declare under sole responsibility that the product: AgGPS 262 receiver complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 4 AgGPS 262 Receiver Firmware Version 2. 00 Release Notes Introduction These release notes describe changes and updates for the Trimble® AgGPS® 262 receiver. [. . . ] Make sure you use the correct capitalization when entering these values. b. Enter the NTRIP Port number: AgGPS 262 Receiver Firmware Version 2. 00 Release Notes 13 c. Enter the mount point: d. Enter the NTRIP user name: e. Enter the NTRIP password: 14 AgGPS 262 Receiver Firmware Version 2. 00 Release Notes 8. To configure the GPRS parameters, press the Down arrow. Note ­ · Ask your cellular network provider for the APN, GPRS user name, GPRS password, and CPIN information you should enter. In some cases the GPRS user name, GPRS password, and CPIN are not required and should be left blank. Some cellular providers provide a SIM card which has the CPIN enabled. If the CPIN is enabled, then you must enter it correctly for your cellular modem to work. [. . . ]