User manual TRAYNOR YS1082

[. . . ] Do not place this product on an unstable cart, stand, tripod, bracket or table. The product may fall, causing serious personal injury and serious damage to the product. Use only with cart, stand, tripod, bracket, or table recommended by the manufacturer or sold with the product. Follow the manufacturer's instructions when installing the product and use mounting accessories recommended by the manufacturer. [. . . ] Channel 1 also contains a fixed mid-frequency scoop that makes acoustic guitar pickups sound more natural. The clip LED can be used to gauge input level to avoid audible clipping. If clipping does occur, lower the signal by turning the volume down on your guitar or reducing the gain on the amplifier's input. The clip LED can be used to gauge input level to avoid audible clipping. If clipping does occur, lower the signal by turning the volume down on your guitar or reducing the Gain control. The High control can be adjusted to accentuate percussive sounds when using a light pick or to attenuate the sound of your fingers moving across the strings. Power switch, Blue LED and AC power connector / fuse holder Channel 1 Input ­ ¼-inch TRS phone jack Channel 1 Gain control Channel 1 Tone controls ­ Bass and Treble Channel 1 Feedback Filter control Channel 2 Input ­ ¼-inch / XLR Combi-jack Channel 2 Gain control Channel 2 Tone control Digital Effects controls Master Volume control Footswitch ­ ¼-inch TRS phone jack AUX Input ­ RCA connectors Line Out (post effects) ­ ¼-inch TRS phone jack Use Channel 1's sweepable notch filter to eliminate feedback caused by the guitar being too close to the amp at higher power. If feedback does occur, rotate the notch control slowly until the feedback is eliminated. To bypass this filter, rotate it fully counter-clockwise to the off position. Please note that if feedback occurs when you are in close proximity to the guitar amp, the notch filter may not help. Therefore either reduce power or move the guitar farther away from the amplifier. This channel accepts line level signals from active acoustic guitars or other line level sources via ¼-inch cables. channel 2 has a flat frequency response , making it ideal for vocals , keyboards , and drum machines. To reduce noise, it is advised that you use balanced cables for interconnection wherever possible. In order to power condenser mics, a 15 volt phantom power is applied to devices connected with an XLR cable. Using a correctly wired XLR cable, phantom power is effectively invisible to balanced dynamic mics and will not cause any damage. The clip LED can be used to gauge input level to avoid audible clipping. If clipping does occur, lower the signal by turning the volume down on your guitar or reducing the Gain control. Channel 2 is also equipped with a tone control for shaping your sound. Turning the knob counter clockwise with do the opposite, removing top end and accentuating the bass. From lush reverb to a swirling rotary speaker simulator, the Acoustic Master Studio uses a DSP (Digital Signal Processor) to create 16 custom Traynor effects. The Mix knob is used to blend in the required amount of the original, clean signal. [. . . ] By rhythmically changing the delay time, you get the sound of a shifting comb filter. The sound of a spinning speaker is akin to a tremolo with Doppler pitch shifting. Compressor ­ Compressors are used to automatically control the volume of the signal passing through them. When the signal goes beyond the compressor's threshold, the volume will automatically be reduced. [. . . ]