User manual THUNDER TIGER MIRAGE V SPEC

[. . . ] For re-building your model effortlessly, the original parts are always identified by an asterisk in front of the part number, please re-use these original parts during the conversion. [. . . ] Please refer your original instruction manual of Titan X50B when disassembling the original model. Check the mesh of Gears (#7 & #10) after this step accomplished, if the mesh has too much play, please add the Washers to eliminate the play for a proper mesh. The hole with a round chamfer goes toward the tail Screw the Shaft End onto the Tail Drive Shaft with a drop of threadlocker as the drawing, but do not over tighten. Add a drop of thin CA glue on the Tail Drive Shaft next to where the bearing should be, and then slide the bearings over the position quickly; the distance from the Shaft Drive End to the Rubber Shaft Bearing Support is approx. Secure the screws into the Frame Spacer when attaching the Tail Support Rod End on the Main Frames. Refer your original manual to assemble the rudder linkage rod back, and re-adjust the length. Preflight check both the mechanism settings and blade tracking is recommended, please refer your original instruction manual of Titan X50B. (Or you may download the new manual of Titan X50 (torque tube version) from www. [. . . ] (Or you may download the new manual of Titan X50 (torque tube version) from www. [. . . ]