User manual TANGENT EXEO AMP

[. . . ] Periodically examine the power cable - if its appearance indicates damage or deteriorated receptacles have it replaced by your service technician. POWER SOURCES: This product should be operated only from the type of power source indicated on the rear panel label. If you are not sure of the type of power supply to your home, consult your product dealer or local power company. For products intend to be operated from battery power, or other sources, refer to the operation instructions. 8. ACCESSORIES: Do not place this product on an unstable surface or support. [. . . ] Use pin-plug cords to connect the terminals to the INPUT terminals on the subwoofer. E. g. compact disc player Connect the CD terminals to the OUTPUT terminals on the compact disc player using the pin-plug cord. Speaker systems ACTIVE SUBWOOFER (NOT INCLUDED) To avoid damaging the speakers with a sudden high-level signal, be sure to switch the power off before connecting the O TPU U T speakers. The amplifier's red speaker terminals are the + (positive) terminals and the black terminals are the ­ (negative) terminals. The + side of the speaker cable is marked to make it distinguishable from the ­ side of the cable. Connect this Recording connections Connect the REC OUT terminals to the input (LINE IN) terminals on the tape deck using the pin-plug cord. marked side to the red + terminals and the unmarked side is the black terminal. Prepare the speaker cords for connection by stripping off approximately 10 mm or less (no more as this could cause LI N E (I N R ) EC PLA O T) Y( U a short-circuit) of the outer insulation. Twist the wires tightly together so that they are not straggly. 1 A B 2 3 1. Tighten the knob and secure the cable. 5 CONNECTIONS PHONO Connect the turntable's output cord L (white) plug to the L PHONO terminal and the R (red) plug to the R PHONO terminal. If your turntable is equipped with a grounding cable, connect it to the unit's GND terminal. But disconnect it if you notice increased humming. A DO UI AUX1 terminals This terminal have an electrical performance which is equivalent to that of the CD terminals which means that it can be used as the audio output terminals for a line level source. Connect this terminal to the OUTPUT terminal on the component using the pin-plug cord. AUX2 terminal This terminal has an increased sensitivity (x4) compared to the other line level inputs. Headphone terminal For connection of a pair of headphones. 6 REMOTE CONTROL INFORMATION By using the provided remote control unit, the receiver can be controlled from your listening position. To use the remote control unit, point it at the REMOTE SENSOR window of the receiver. Notes: - Even if the remote control unit is operated within the effective range, remote control operation may be impossible if there are any obstacles between the unit and the remote control. - If the remote control unit is operated near other appliance which generate infrared rays, or if other remote control devices using infrared rays are used near the unit, it may operate incorrectly. Precautions concerning batteries -Be sure to insert the batteries with correct positive+ and negative ­ polarities. - When the remote control unit is not to be used for a long time (more than a month), remove the batteries from the remote control unit to prevent them from leaking. [. . . ] Loudness Loudness bypass any EQ function, as it uses the EQ to generate the loudness curve. Display ­ Time Out Time limits of 5 and 20secs can be selected and off. Time Out means the display switches off, if no actions are taken with the time limit. 11 OPERATION AND FUNCTION HP Filter A highpass filter can be set on and off, to match the system with a active subwoofer. [. . . ]