User manual SUUNTO BIKE POD

[. . . ] NOTE: The wristop-computer functions related to the use of your Suunto Bike POD are explained in the individual Suunto t3, t4, and t6 instruction manuals. You can download the latest version of the manuals at www. suunto. com/ training. EN 2. PAIRING YOUR BIKE POD Before you can use your Suunto Bike POD, you have to pair it with your Suunto wristop computer. To be able to listen to a specific radio station, you have to tune the radio to the correct frequency. [. . . ] Fit the quick-release lever to the hub, with the lever to the left (to the right when using disc brakes). Close the lever, taking care to position it horizontally towards the rear (+/­ 45°). Adjust the tension on the adjusting nut so that sufficient force is applied when the locking lever is moved to the "CLOSE" position (consult your retailer). When the locking lever can be moved to the "CLOSE" position too easily, the wheel is not held in place with sufficient force. If this is the case, put the locking lever in the "OPEN" position and tighten the adjusting nut to increase the force. The end of the skewer should not be deeper than 2 mm (1/16 inch) inside the nut. +/- 45 6. Attach the holder for your Suunto wristop computer to the handle bar with the flat part facing up. INSTALLING THE MAGNET MOUNT Position the magnet mount on a spoke so that it passes in front of one of the marks on the lever. The magnet must be turned towards the Bike POD. · Hub (1) · Magnet (2) · Bike POD (3) 3. 3. ACTIVATION AND DEACTIVATION Your Bike POD is activated automatically when the spoke magnet passes the Bike POD, i. e. It stays active throughout the cycling trip and for half an hour after the Bike POD has stopped receiving readings from the magnet. 3. 4. CONNECTION To use your Bike POD, you must establish a connection between it and your wristop computer. To be able to receive the radio broadcast signal, you need to switch the radio on. Similarly, for your wristop computer to be able to receive the signal from your Bike POD, the devices must be connected. You need to establish the connection every time you want to use your wristop computer with your Bike POD. Suunto t3 or Suunto t4: If the connection fails, the message "Searching" disappears from the bottom row of the display and the selected shortcut returns. In this case, spin the front wheel again to ensure that the Bike POD is active and try again. Suunto t6: If the connection fails, "NO DEVICES FOUND" is displayed on the screen. In this case, spin the front wheel again to ensure that the Bike POD is active and try again. 3. 5. CALIBRATION Suunto Bike POD measures your bike's speed and distance from the rotation of the front wheel. The wristop computer needs a specific calibration factor that takes the wheel size into consideration. [. . . ] Suunto Oy and its subsidiaries do not assume any responsibility for losses or claims by third parties that may arise through the use of this device. Suunto's Quality Assurance System is certified by Det Norske Veritas to be ISO 9001 compliant in all Suunto Oy's operations (Quality Certificate No. AFTER SALES SERVICE If a claim under warranty appears to be necessary, return the product, freight prepaid, to your Suunto representative who is responsible for having your product repaired or replaced. Include your name, address, proof of purchase and/or service registration card, as required in your country. [. . . ]