User manual STRONG SRT ANT 15

[. . . ] With the multi-functional mounting materials supplied you can install the antenna on a wall, on your balcony or on a pole outside the house. This DVB-T Antenna is an "Active type" antenna, it has a built-in low noise amplifier that amplifies the received signal for better performance. The antenna therefore needs 5 V power supplied by your terrestrial receiver, or by an AC adaptor (supplied with the antenna). [. . . ] Normally the input connector on your receiver is marked as "ANT" (in) or as "RF" (in). Connect the other end of the cable to the connector on the power injector that is marked as "Receiver". Take the supplied "long" coaxial cable and connect the end with the "F connector" (screw type connector) to the antenna. Carefully press the inner lead of the cable into the Female-F connector at the back of the antenna. Connect the other side of the cable to the connector at the power injector, it is marked as "Antenna". Insert the adapter to the 230 V mains power and insert the connector at the end of the lead to the power injector - it is marked as "DC 9 - 12 V". 4 PART 1 · English For point B - please see drawing below: Powering by Adaptor Indoor Outdoor AC Adaptor (DC 9 V) STB or Digital TV Coaxial Cable Power injector Water-Drop Loop (recommended) Coaxial Cable 5. 0 INSTALLATION OF THE ANTENNA 1. Press the [MENU] button on the remote control of your Digital Terrestrial Receiver. Select the Menu on your receiver that shows you the signal level indicators. (Normally you can find the signal meter in the Channel Scan field of the menu). Now optimise the signal strength by finding the best position for the antenna. Keeping the antenna in your hand, try to reach the highest or best possible position. Slowly move the antenna to different positions around the house, at the same time monitor the signal bars in the menu, once the signal indicator shows the maximum signal, fix the antenna on that position. Note - It is recommended NOT to place the antenna near to: n Devices that are strong source of radiation or interference such as DECT and GSM telephones, Transmitters, Microwaves, etc. [. . . ] Power Saving To save power and money, please put the product into standby mode when not in use. We also recommend disconnection from mains supply when not in use for longer periods of time. Batteries Do not dispose of the batteries from your handset with your domestic waste. [. . . ]