User manual STRONG SRT ANT 12 ECO

[. . . ] Active Indoor Antenna SRT ANT 12 ECO User Manual Mode d’emploi Bedienungsanleitung Manuale d’uso Manual de uso Bruksanvisning Használati kézikönyv Uživatelský manuál Instrukcja obsługi Uputstvo za upotrebu Руководство пользователя PART 1 Table of contents 1. 0 INTRODUCTION 2. 0 PACKAGE CONTENTS 3. 0 SAFETY NOTES 4. 0 CONNECTING THE ANTENNA 5. 0 INSTALLATION OF THE ANTENNA 1 1 2 2 3 English 1. 0 INTRODUCTION Thank you for purchasing the STRONG SRT ANT 12 ECO DVB-T/T2 antenna. This antenna has been specially designed to receive digital terrestrial signals from the air. [. . . ] 5. Connect the other side of the coaxial cable to your Digital Terrestrial Receiver. Normally the input connector on your receiver is marked as “ANT” (in) or as “RF” (in). 6. Connect your Digital Receiver to the 230 V main power. 2 PART 1 1. AC Outlet 2. Adaptor (230 V AC/12 V DC) 3. Antenna (Rear View) Standing (Vertical) 4. TV 5. Coaxial cable 6. HDMI or SCART cable (optional) 7. Digital Terrestrial Receiver DVB-T/T2 5. 0 INSTALLATION OF THE ANTENNA A: To power the antenna with Digital Terrestrial Receiver 1. Turn on your TV set and turn on your Digital Terrestrial Receiver. 2. Press the “MENU” button on the remote control of your Digital Terrestrial Receiver. Check in the Set Up or Installation menu of your receiver if the antenna power is set to “ON”. (Normally this is indicated in the menu as ANT power, Ext antenna power or Active antenna power. ) Refer to the user manual of your Digital Terrestrial Receiver. 3. Select in the menu of your receiver the field that shows the signal level indicators. (Normally you can find the signal meter in the Channel Scan field of the menu. ) 4. Now optimise the signal strength by finding the best position for the antenna. Keep the antenna in your hand and try to reach the highest possible position. Now slowly turn the antenna around its axis (in the horizontal field), at the same time monitor the signal bars in the menu, once the signal indicator shows the maximum signal, fix the antenna on that position. 5. It is important to place the antenna in such way that an acceptable signal level is assured. You can optimise the signal strength by moving the antenna to different locations in your room, for example place it near a window, or place it on a high placed book-shelf. NOTE:  is recommended NOT to place the antenna near to: It „„ Devices that are strong source of radiation or interference such as DECT and GSM „„ Devices with high power consumption such as electrical heater, air conditioner, hairdryers, etc. telephones, transmitters, microwaves, etc. 3 English PART 1 B: To power the antenna with extra power adaptor 1.  se this installation if your Digital Terrestrial Receiver does not support an active antenna. U 2. Connect the supplied power adaptor to the “DC IN” connector on the back of the antenna. [. . . ] In consequence of continuous research and development technical specifications, design and appearance of products may change. All product names are trademarks or registered trademarks of their respective owners. [. . . ]