User manual STRONG SRT ANT 10 ECO

[. . . ] Digital Active Indoor Antenna SRT ANT 10 ECO User Manual Picture similar Table of contents 1. 0 INTRODUCTION 2. 0 PACKAGE CONTENT 3. 0 SAFETY NOTES 4. 0 CONNECTING THE ANTENNA 1 1 2 2 Thank you for purchasing the STRONG SRT ANT 10 ECO DVB-T/T2 Antenna. This antenna has been specially designed to receive digital terrestrial signals from the air. It can be connected to any Digital Terrestrial Receiver (DVB-T/T2), and is designed for INDOOR use only. [. . . ] Normally the input connector on your receiver is marked as “ANT” (in) or as “RF” (in). Connect your Digital Receiver to the 230 V main power. 2 1. AC Outlet 2. AC Adaptor (DC 12 V) (Optional) 3. Antenna (Rear view) 4. TV 5. Coaxial cable 6. HDMI cable or SCART cable (optional) 7. Digital Set Top Box 4. 1 INSTALLATION OF THE ANTENNA 1. Turn on your TV set and turn on your Digital Terrestrial Receiver. 2. Press the “MENU” button on the remote control of your Digital Terrestrial Receiver. Check in the Set-Up or Installation menu of your receiver if the antenna power is set to “ON”. (Normally this is indicated in the menu as ANT power, Ext Antenna power or Active antenna power. ) * 3. Select in the menu of your receiver the field that shows the signal level indicators. (Normally you can find the signal meter in the Channel Scan field of the menu. ) 4. Now optimise the signal strength by finding the best position for the antenna. Keep the antenna in your hand, try to reach the highest possible position. Now slowly turn the antenna around its axis (in the horizontal field), at the same time monitor the signal bars in the menu. Once the signal indicator shows the maximum signal, fix the antenna on that position. 5. It is important to place the antenna in such way that an acceptable signal level is assured. You can optimise the signal strength by moving the antenna to different locations in your room, for example place it near a window, or place it on a high placed book-shelf. NOTE:  is recommended NOT to place the antenna near to: It „„ Devices that are strong source of radiation or interference such as DECT and GSM „„ Devices with high power consumption such as electrical heater, air conditioner, hairdryers, * If you can not find this option in the menu of your Digital Terrestrial Receiver, please check in your user manual if your receiver supports active antenna power (5 V DC via the RF cable). If you are not sure; please contact your dealer. telephones, transmitters, microwaves, etc. etc. 3 English In case this option is not supported by your Digital Receiver you need to connect an external power supply to power the antenna. [. . . ] „„ Make sure that both inner cable and shielding are properly connected to the connectors to assure active antenna power supply and to avoid short circuit in the cable. If you extend the cable, please keep the cable as short as strictly needed. Extending the cable or using a bad quality cable will reduce the performance of your antenna. 4 [. . . ]