User manual STRONG SRT ANT 10

[. . . ] This DVB-T Antenna is a "Active type" antenna, it has an build-in low noise amplifier that amplifies the received signals for better performance. We recommend you to carefully read this user manual before you install the antenna, this will help you to get the best performance out of your antenna. [. . . ] It is important to place the antenna in such way that an acceptable signal level is assured. You can optimise the signal strength by moving the antenna to different locations in your room, for example place it near a window, or place it on a high placed book-shelf. NOTE: It is recommended NOT to place the antenna near to: n Devices that are strong source of radiation or interference such as DECT and GSM telephones, Transmitters, Microwaves, etc. n Devices with high power consumption such as Electrical Heater, Air conditioner, Hairdryers, etc. * If you can not find this option in the Menu of your Digital Terrestrial Receiver, please check in your user manual if your receiver supports active antenna power (5 Volts DC via the RF cable). In case this option is not supported by your Digital Receiver you need to connect a external power supply to power the antenna. Ask your electronic dealer for an external 230 V AC to DC power adapter that supplies 9 Volts DC, 100 mA. Note that the + and the ­ of the power adaptor are located as follows: The connector for the external power supply can be found at the backside of the antenna. NOTE: T he antenna will not function properly if the build-in amplifier is not powered. Therefore it is required to supply the antenna with power via the RF cable or via a external adapter. Extension of the RF cable: In some cases you may need to extend the standard supplied RF cable, we advise you to only do this if you can not get a optimal signal strength within the reach of the standard cable. If you are to extend the RF cable, then please note following comments: n Use a good quality RF cable, 75 Ohm type only with proper shielding n Use well shielded connectors, your dealer can advise you on this n Make sure that both inner cable and shielding are properly connected to the connectors to assure active antenna power supply and to avoid short circuit in the cable If you extend the cable, please keep the cable as short as strictly needed. Extending the cable or using bad quality cable will reduce the performance of your antenna. Subject to alterations. [. . . ] We also recommend disconnection from mains supply when not in use for longer periods of time. Batteries Do not dispose of the batteries from your handset with your domestic waste. [. . . ]