User manual STRONG SRT 7504

[. . . ] Digital high Definition satellite Receiver sRT 7504 návod k obsluze Používateľská príručka User manual USB Recording 4000 Channels 20 Timers Subtitles Picture similar Obr. 5 3 4 6 7 9 11 12 11 14 16 18 20 21 24 25 27 28 20 21 5 8 10 12 13 15 17 19 22 23 26 29 22 23 1. 2. 3. Obr. 6 Satelitní anténa Koaxiální kabel HDMI kabel SCART kabel 100-240 V~ / 12 V Obr. 7 USB zařízení Koaxiální kabel 100-240 V~ / 12 V USB kabel Obr. [. . . ] In Delete TP a message will be displayed to apply your changes, use pq to select Yes to apply or No to cancel and confirm with OK. Scan Mode H  ere you can decide which channels you want to scan for: Either scan all channels FTA & $, for Free-To Air only FTA or use CA to scan for scrambled channels only. Channel Type TV & Radio will scan for TV and radio channels, TV for TV channels only and Radio for radio channels only. After you have adjusted the settings for the preferred scan process, move to Scan selected satellite with pq and then select the search method with tu. You can select between following procedures: Scan selected satellite  Scanning the selected satellite. Search All Sat  Scanning the selected satellites. * Search TP  Scanning the selected transponder. NIT 18 Fast scan:  rescan the channel list supplied by the operator that you have chosen. When all settings have been made, press OK at the preferred scan method to start this scan process or to quit without scanning. All newly found channels will be stored at the end of the channel list. *Only available if more than one satellite has been setup. Note  (Network Identification Table): This option will scan on the NIT table of NIT the satellite and allows you to receive new appeared channels. English Note  When you want to add technical data for a new transponder we recommend verifying it by consulting websites like: www. lyngsat. com or www. kingofsat. net or you can refer to professional journals. 7. 1. 3 System Settings Use the System Settings menu to configure settings for language, audio, video, look and feel of your receiver. Choose a setting with pq and press OK to list the possibilities or use tu to change the value of the highlighted setting. Please also read the displayed instructions for each screen carefully. Language:  Here you can change the language for the On-Screen-Display, use tu to select your preferred language. It affects the menu language of your receiver so all menus and messages will be displayed in the chosen language. For details, see chapter 7. 1. 3. 1 HDMI or 7. 1. 3. 2 SCART. Audio Output:  Here you can adjust the settings for your digital audio output. If a device that can decode Dolby® Digital is connected, use the setting BitStream. For details, see chapter 7. 1. 3. 4 Select Subtitle Language Start up channel  this menu you can select your start up channel. Select Last watched if you In want to start with the last viewed channel when the receiver was switched off. To switch on with a specific channel, select Fixed Channel by pressing tu. Press pq or P+/P- to scroll in the list and confirm your selection with OK. Banner display time:  Defines the time for displaying the information banner. Press tu to choose between OSD transparency:  25%, 50%, 75% and fifty-fifty. When all settings have been made, press to leave the System Settings menu. [. . . ] Connect your receiver temporarily with a SCART cable to see the menu again and change the HDMI resolution to a lower value. The weather is very bad and the satellite signals are temporary blocked. Check the antenna cable, replace the cable, or connect the cable tightly to the receiver. Trees grow between the dish and satellite position (the sky must be 100% clear) Set the values of the tuner parameters correctly in the menu Installation -- Antenna Setup/Channel Search. [. . . ]