User manual STEINEL NIGHTMATIC 3000

[. . . ] +4 20/515/22 01 26 Fax: +4 20/515/26 15 25 e-mail: info@elnas. cz http://www. elnas. cz PL NightMatic 3000 Vario PUAG AG Oberebenestrasse 51 CH-5620 Bremgarten Tel. : + 41/56/6 48 88 55 GB SAET-94 S. L. Industrial Cova Solera C/Atenas, 5 E-08191 Rubi (Barcelona) Tel. : + 34/93/5 88-67 25 e-mail: saet94@retemail. es P LANGE ¸UKASZUK Sp. j. Byków 25a PL-55-095 Mirków Tel. : + 48/71/3 98 08 00 Fax: + 48/71/3 98 08 02 LT D GB F NL I E S DK FIN N STEINEL U. [. . . ] In doing so, seasonal modifications in the light conditions are automatically taken into account. Installation on the housing, pierce the condensation water holes at the bottom. PE PE (phase) (Phase) (neutral) (Nullleiter) Connection The appliance has the following marked connections: N = neutral terminals (2 x, usually blue) L = phase terminal (usually black or brown) L' = connection to the switched phase If in doubt, the cable must be identified with a voltage tester. The phase (L) and neutral (N) conductors are to be connected according to the terminal assignment. The service lead (light fixture) is connected to the second neutral terminal (N) and phase (L'). Any green/yellow protective-earth conductors present must be secured to the clamp provided. Important: if the connections are reversed, this will cause a subsequent short circuit in the unit or your fuse box. In this case, the individual conductors must be reidentified and reinstalled. Examples of night economy mode: button button button Leuchte Light Wall mounting Warning: installation involves a mains connection. Therefore, switch off the power first and check freedom from voltage with a voltage tester. Installation of the photoelectric lighting controller involves work on the mains power supply; this work must therefore be carried out professionally in accordance with regulations. Please note that the photoelectric lighting controller must be protected by a 10 A circuit breaker. The NightMatic 3000 Vario can be installed directly ad6 jacent to the light fixture, if desired. A microprocessor distinguishes between the surrounding and consumer light, thereby ensuring constant light measurements. Using a screwdriver, loosen the four screws on the housing by turning anticlockwise and remove the housing cover. Hold the electronic housing against the wall and mark the drilling holes. During installation, ensure that the leads are always inserted from below if possible. [. . . ] Repair Service: Our Customer Service Department will repair faults not covered by warranty or after the warranty period. Please send the product well packed to your nearest Service Centre. Troubleshooting Malfunction NightMatic 3000 Vario without power Cause Fuse has blown, not switched ON, lead disconnected Short-circuit Consumer faulty No power supply Surroundings still too bright Remedy Replace fuse, switch ON mains switch, check wiring with voltage tester Check connections Change consumer Refer to "NightMatic 3000 Vario without power" Wait until switching brightness is achieved. Set a new switching value, if required, using the button Wait until sufficient brightness achieved. [. . . ]