User manual STEINEL IR QUATTRO

[. . . ] SAVE THESE INSTRUCTIONS ~ Do not allow children to play on or in the appliance. Close supervision is necessary when the appliance is used near children. Keep children away from the washer when in use. ~ The drum door glass will be hot 4 IMPORTANT SAFETY INSTRUCTIONS Technical safety visible damage. ~ Do not install or use a washer with ~ Before connecting the machine, ~ Faulty components must only be replaced with genuine Miele spare parts. ~ Installation, repair and maintenance work should be performed by a Miele authorized service technician. Work by unqualified persons could be dangerous and may void the warranty. [. . . ] The fabric softener / liquid starch will be dispensed during the final rinse. A small amount of water will remain in the compartment at the end of the program. If starching frequently, clean the dispenser compartment and especially the siphon tube. , Do not use dye removers in this washer! 24 Using the washer 7. Select Delay Start (if desired) Delay start allows you to delay the start of a program from 30 minutes to a maximum of 24 hours. Start in: MG G P G G GM Warm 0:30 h MG G G G P GM High spin ^ With every touch of the "Delay" button, the start is delayed longer. ­ For a delay less than 10 hours, the delay time extends in 30 minute increments. ­ For a delay more than 10 hours, the delay time extends in 1 hour increments. Adjust To adjust the "Delay Start" time cancel then reset. 25 Using the washer 8. Activate the Child Lock (if desired) The Child Lock prevents a program from being canceled. ^ Press and hold the "Pre-wash" button until the display shows: X ^ Press the flashing "Start" button. Once the delayed start time has elapsed or immediately after the program starts, the approximate program running time is displayed. The washer calculates the water absorbency of the laundry in the first 8 minutes. ^ Clean the drum with a stainless steel cleaner specially formulated for use on washing machines (available from Miele). , Do not use chemical solvents, abrasive cleaners, glass or all-purpose cleaners!Once the program is finished: ^ Clean the dispenser drawer as described on the following pages. 30 Cleaning and care Cleaning the dispenser drawer Regularly remove any detergent residue. ^ Remove the lid from the bleach container and clean both parts thoroughly in warm water. ^ Pull the detergent drawer out until it stops, press down the release catch, and remove the drawer from the washer. ^ Clean the "Heavy Soil" and "Main Wash" compartments with warm water. ^ Put the bleach container back in the "Main Wash" compartment. ^ Remove the bleach compartment to clean it. 31 Cleaning and care Cleaning the siphon and softener channel Cleaning the detergent drawer niche 1. Pull the siphon out of the "Softener" compartment, and rinse under warm running water. Put the siphon back in place. ^ Use a bottle brush to remove any detergent residue and lime deposits from the jets inside the detergent drawer. ^ Slide the drawer back into place. ^ Clean the fabric softener channel with warm water and a brush. Clean the siphon tube and fabric softener channel more often if you frequently use liquid starch. Liquid starch tends to build up. 32 Cleaning and care Cleaning the water inlet filters The washer has two water inlet filters to protect each inlet valve. These filters should be checked and cleaned if necessary every 6 months. [. . . ] If the water pressure is greater that 145 psi (10 bar) a pressure reducer must be installed. If the water pressure is below 15 psi (1 bar) there will not be enough water available for a complete fill. Tips for a hot water connection The hot water temperature from the hot water valve must not exceed 140°F (60°C); the ideal temperature is 130°F (55°C). If there is no water pressure at the hot water inlet, the unit will automatically switch to cold water after several minutes. 50 Plumbing Drainage The 5 ft (1. 5 m) drain hose may be connected as follows: 1. [. . . ]