User manual STEINEL HF 360 COM 1

[. . . ] Extension cords do not guarantee the required safety of the appliance (e. g. maritime use or for use in mobile installations such as recreational vehicles or aircraft. However, under certain conditions it may be possible for an installation in these applications. the appliance or attempt any servicing unless specifically recommended in these operating instructions. fire, electric shock or injury to persons while using your appliance follow basic safety precautions, including the following: the appliance. ~ Read all instructions before using ~ Before connecting the machine, ~ GROUNDING INSTRUCTIONS This appliance must be grounded. [. . . ] If the delay start is set, the remaining times elapses in the display. Once the delayed start time has elapsed or immediately after the program start, the approximate program running time is displayed. The drum light turns off once the program starts. ^ With every touch of the "Delay" button, the start is delayed longer. ­ For a delay less than 10 hours, the delay time extends in 30 minute increments. ­ For a delay time more than 10 hours, the delay time extends in 1 hour increments. 23 Using the washer 10. Activate the Child Lock (if desired) The Child Lock can be activated to prevent a child from canceling the program and opening the door at the end of a program. ^ Press and hold the "Heavy soil" button until the display shows: 11. Program end During the "Anti-crease" program the display shows "Anti-crease" alternating with "End". shrink or discolor) during the next wash cycle. X Locked Deactivate the Child Lock ^ Press the "Heavy soil" button until the display shows: W Ready to use Once the program has finished, the Child Lock must be deactivated. ^ Check the folds of the door seal for any small articles. ^ Activate the Child Lock so children or animals do not find their way into the drum. 24 Using the washer Canceling a program A program can be canceled any time after the program start. Interrupting a program ^ Turn the washer off. To continue: ^ Turn the washer on again. Changing a program A program change is not possible once the program has started. ^ Add 1/4 cup of detergent and/or bleach to the respsective compartment (if desired). ^ Run the program as normal through to completion. Detergent residue should be cleaned out regularly. Press down on the red release lever and pull the drawer out of the machine. ^ Clean the detergent drawer with warm water. 27 Cleaning and care ^ Clean the siphon tube. Remove the siphon tube from the compartment § and rinse under warm water. Replace the siphon tube. ^ Using a bottle brush remove any detergent or lime deposits from the water inlet valves at the top of the detergent drawer niche. Cleaning the liquid detergent inserts Clean the siphon tube and fabric softener channel more often when frequently using liquid starch. Liquid starch tends to stick. ^ Push the insert apart and remove the siphon for easy cleaning. 28 Cleaning and care Cleaning the water inlet filters The washer has two water inlet filters to protect each inlet valve. These filters should be checked and cleaned if necessary every 6 months. ^ Unscrew the inlet hose from the valve by turning the connector counterclockwise using a wrench if necessary. ^ Remove the rubber seal, 1, from the connector. ^ Using needle nose pliers, grasp the plastic filter, 2, and pull it out of the hose connector. [. . . ] If the machine is being connected only to a cold water supply, both the hot and cold water intake hoses must be attached to the cold water valve through the use of a Y adapter (available at a hardware store). Both hoses must be connected to a water source or the machine will not function properly. If the water pressure is greater that 145 psi (10 bar) a pressure reducer must be installed. If the water pressure is below 15 psi (1 bar) there will not be enough water available for a complete fill. [. . . ]