User manual SONY ST-S550ES

[. . . ] ⷠUnplug the unit from the wall outlet if it is not to be used for an extended period of time. The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. ⷠAC power cord must be changed only at the qualified service shop. [. . . ] Place the unit in a location with adequate ventilation to prevent heat buildup and prolong the life of its components. ⷠDo not place the unit near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. ⷠDo not place anything on top of the cabinet which might block the ventilation holes and cause malfunctions. Clean the cabinet, panels and controls with a soft cloth lightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. If you have any question or problem concerning your unit that is not covered in this manual, please consult your nearest Sony dealer. Check that you received the following items with the tuner: · Unwrap 3 lengths of the braided lead wire from around the frame of the aerial. 3 Before you get started ⷠTurn off the power to all components before making any connections. ⷠDo not connect the mains lead until all of the connections are completed. If you connect an outdoor aerial, be sure to connect a ground wire (not supplied) to the AM ANTENNA y terminal (in addition to the AM loop aerial) for lightning protection. Connect the mains lead to a wall outlet after completing all of the previous connections. Use the number buttons (1-9, 0/10 and >10) to select a preset number. Press + for a higher frequency Press ­ for a lower frequency For automatic tuning Hold down TUNING + or ­ for about 1 second and release it when the frequency numbers start changing. When the tuner locates a station, it stops automatically and "TUNED" appears in the display. If "MEMORY" goes out from the display before you select the preset number Repeat step 4 until the desired station is received. when an FM stereo program is noisy When the tuner receives an FM stereo program, the STEREO indicator lights in the display window. if the stereo program is noisy , press STEREO/MONO to change the tuning mode over to MONO. This eliminates the stereo effect, but the noise will be greatly reduced. [. . . ] This eliminates the stereo effect, but the noise will be greatly reduced. This tuner lets you recall preset stations directly, by entering the number of the preset you desire, or by scanning the preset memory. Press MEMORY SCAN again as soon as the station you desire is tuned in. [. . . ]