User manual SONY SRS-BTV25

[. . . ] Make sure none of the audio devices are positioned too close to the TV set. The brightness of the POWER indicator (green) may become unstable when the volume is turned up. When using the Bluetooth connection ©2011 Sony Corporation Printed in China No sound Ensure that this system is not too far from the Bluetooth stereo audio source device, and that this system is not receiving interference from a wireless LAN, another 2. Check that the Bluetooth connection is made properly between this system and the Bluetooth stereo audio source device. [. . . ] Pairing mode is cancelled and the system is turned off after about 5 minutes. If the pairing mode is cancelled while performing this procedure, start over from step 2. * Even when the Bluetooth standby function is activated, the indicator will be off if there is no pairing information. The nameplate indicating Sony trademark, model number and electrical rating is located on the bottom exterior of this unit. Before operating the system, be sure that the operating voltage of the system is identical with that of your local power supply. By using the Bluetooth standby function, you can make the system turn off temporarily and wait for the Bluetooth connection. If pairing information has not been memorised, the system enters pairing mode automatically when the BLUETOOTH PAIRING button is pressed. There is no need to hold the BLUETOOTH PAIRING button for any more than 2 seconds. And press the / button for any more than 2 seconds while the system is turned on. If you start the Bluetooth connection, the system turns on automatically and starts communication. When connecting or disconnecting the AC power cord (mains lead), turn off the system beforehand. Do not leave the system in a location near heat sources, or in a place subject to direct sunlight, excessive dust, moisture, rain or mechanical shock. When pairing, be sure to place both the Bluetooth devices within 1 m of each other. When waiting for the Bluetooth connection, you can reduce power consumption by using the Bluetooth standby function, rather than leaving the system turned on. Maximum communication range may shorten under the following conditions. , declares that this equipment is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. De/ Norway: Use of this radio equipment is not allowed in the geographical area within a radius of 20 km from the centre of Ny-Ålesund, Svalbard. italy: Use of the RLAN network is governed: ­ with respect to private use, by the Legislative Decree of 1. 105 indicates when free use is permitted; ­ with respect to the supply to the public of the RLAN access to telecom networks and services, by the Ministerial Decree 28. Should any solid object or liquid fall into the system, have the system checked by qualified personnel before operating it any further. Although this system is magnetically shielded, do not leave recorded tapes, watches, personal credit cards, or floppy disks with magnetic coding in front of the system for an extended period of time. 1 kHz) *1 The actual range will vary depending on factors such as obstacles between devices, magnetic fields around a microwave oven, static electricity, reception sensitivity, aerial's performance, operating system, software application, etc. [. . . ] Common Problems No sound Check that both this system and the source device are turned on. Turn up the volume of the source device as high as possible to the extent that sound is not distorted. Power DC 13 V Rated power consumption 12 W Operating temperature 5 ºC - 35 ºC Power voltage 100 V - 240 V AC Dimensions (w/h/d) Approximately 145 mm × 145 mm × 145 mm Mass Approximately 500 g * Bluetooth devices to be connected with the system are required to support A2DP (Advanced Audio Distribution Profile). If the AUDIO IN indicator (amber) is activated, this step is not required. [. . . ]