User manual SONY PS-3300

[. . . ] warning to the customers in the United Kingdom THIS APPARATUS MUST BE EARTHED TO YOUR 3-PIN PLUG IN ACCORDANCE WITH FOLLOWING INSTRUCTIONS. IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Green-and-yellow: Earth (safety earth) Blue: Neutral Brown: Live As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug proceed as follows : The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the letter E or by the safety earth symbol ;è: or coloured green or green and-yellow, The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. [. . . ] And is applied in accordance with the tracking force, Incorrect anti'skating compensation results in sound distortion and uneven we8r on bath the stylus and the record Such as direct applying any pressure or in minimize any warpage. Don't put anything but records on a turntable_ · Don 't place anything but the spare cartridge and 45-rpm Adaptor on the cabinet. When connecting to an accessory ac outlet on the amplifier, use an unswitched type outlet. First con neet the mains lead to the ac input of the turntable and then to the ac outlet. Check that the phono cord and mains lead are not caught under any foot of the cabinet. Leave a little slack in the connecting cord to allow for in advertent shock or vibration. The Tonearm automatically returns to its rest and the unit is turned oft. Grasp the green stylus assembly between the thumb and fore finger and pull gently to remove the stylus. @ Select the speed (either 33 or 45) according to the record speed that you wish to play. Adjust the speed with the Pitch Control until the pattern appears stationary*. The motor shaft is factory lubrrcated for the life of the turntabie. Clean the cabinet and dust cover periodically with a soft dry cloth. The Tonearm will automatically lower onto the record and the record playing begins. Adjust the sound level, stereo balance and tone quality of the amplifier according to your preference . [. . . ] ETurntable not level elncorrectly placed on or near a speaker eDusty stylus eWorn stylus or defective record (The stylus life is approx, 400 hours of playing time. 5g Cartridge weight range 4 ~ lOg Cartridge Type Frequency range Channel separation Output voltage Load impedance Tracki ng-force Stylus Weight General Power requirements e Turntable not level elmproper tracking force (See page 7. E Loose ground wire connection to the amplifier eLoose connection between the Shell and the Tonearm (See "Preparation" on page 6. [. . . ]