User manual SONY MZ-E710

[. . . ] Refer to them whenever you call upon your Sony dealer regarding this product. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, used, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Various ways of recording Various ways of playback "FAST" appears in the display, and fast playback starts at a speed of 1. Each time you press PLAY MODE, the play mode indication changes as shown in the next page. Track number or track name* To know the time and track name You can see in the display window the name, number, remaining time, and recorded time of the track being played. Each time you press DISPLAY, the display changes as shown on the next page. To prevent the buttons from being accidentally operated while carrying the recorder, use this function. ** The indications show the date and time when you started recording or added the track mark. If you record without setting the clock or play an MD that has no recorded date, "- - y - - m - - d" and "- - : - -" appear. Connect the 2 jack of the recorder to a tape player or an amplifier with a line cable (RK-G134, or RK-G129, not supplied). You can listen to an MD with your stereo system or record on a cassette tape, etc. To 2 (headphones) To listen with a monaural player You can edit your recordings by adding or erasing track marks, or erasing tracks. While the recorder is playing an MD, press TRACK MARK on the recorder at the point you want to mark. To remove the AC power adaptor from the wall outlet, grasp the adaptor plug itself; never pull the cord. Road safety Do not use headphones while driving, cycling, or operating any motorized vehicle. It can also be potentially dangerous to play your recorder at high volume while walking, especially at pedestrian crossings. You should exercise extreme caution or discontinue use in potentially hazardous situations. If you experience a ringing in your ears, reduce the volume or discontinue use. This will allow you to hear outside sounds and to be considerate of the people around you. Heat may build up in the recorder if it is used for an extended period of time. Do not place the cartridge where it will be subject to light, temperature, moisture or dust. Never use the recorder where it will be subjected to extremes of light, temperature, moisture or vibration. ⷠNever wrap the recorder in anything when it is being used with the AC power adaptor. Clean the recorder casing with a soft cloth slightly moistened with water or a mild detergent solution. [. . . ] Audio playing system MiniDisc digital audio system Laser diode properties Material: GaAlAs Wavelength: l = 780 nm Emission duration: continuous Laser output: less than 44. 6 µW (This output is the value measured at a distance of 200 mm from the lens surface on the optical pick-up block. Outputs Headphones: stereo mini-jack, maximum output level 5 mW + 5 mW, load impedance 16 ohm Power output DC operation Speaker 220 mW (at 10% harmonic distortion) Power requirements Three size AA (LR6) alkaline batteries (not supplied) Sony AC Power Adaptor AC-E45HG (not supplied) connected at the DC IN 4. AC-E45HG AC power adaptor LIP-12 Lithium ion rechargeable battery ACP-MZ60A* AC Power adaptor/ Battery charger ECM-909A, ECM-727P, ECM-717 Stereo microphones ECM-T140, ECM-T110 Monaural microphones MDR-E747, MDR-E535 Stereo dynamic earphones MDR-D55, MDR-D33 Stereo headphones RK-G134, RK-G128 Line cables MDW-74/74A, MDW-74L/74R/74Y, MDW-60/60A Recordable MDs CK-MD4 MiniDisc carrying case CK-MD10 MiniDisc filing box * ACP-MZ60A can only be used as a battery charger. [. . . ]