User manual SONY MDR-NWBT10N

[. . . ] Check that music is being played back by the Bluetooth device, and turn up the volume of the connected device as necessary. Check that the Bluetooth headphones are turned on, and their volume is not set too low. Poor radio wave conditions may interfere with high bit rate sound transmission. For details on supported models of these Bluetooth headphones, see the "Customer support Web site". [. . . ] On certain batteries this symbol might be used in combination with a chemical symbol. The chemical symbols for mercury (Hg) or lead (Pb) are added if the battery contains more than 0. By ensuring these batteries are disposed of correctly, you will help prevent potentially negative consequences for the environment and human health which could otherwise be caused by inappropriate waste handling of the battery. the recycling of the materials will help to conserve natural resources. In case of products that for safety, performance or data integrity reasons require a permanent connection with an incorporated battery, this battery should be replaced by qualified service staff only. to ensure that the battery will be treated properly , hand over the product at end-of-life to the applicable collection point for the recycling of electrical and electronic equipment. For all other batteries, please view the section on how to remove the battery from the product safely. hand the battery over to the applicable collection point for the recycling of waste batteries. For more detailed information about recycling of this product or battery, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. To enter pairing mode Press and hold the /POWER button for more than 7 seconds* while the Bluetooth headphones are turned off. the indicator flashes blue and red alternatively and the Bluetooth headphones enters pairing mode. * After purchasing the Bluetooth headphones, when pairing for the first time, press and hold the /POWER button for about 2 seconds while the Bluetooth headphones are turned off. If pairing is not established within about 5 minutes, pairing mode will be cancelled and the Bluetooth headphones will turn themselves off. IBM PC/AT compatible computer with pre-installed with any of the following operating systems and USB port: Windows XP Professional (Service Pack 3 or later)/Windows Vista Home Basic (Service Pack 1 or later)/Windows Vista Home Premium (Service Pack 1 or later)/Windows Vista Business (Service Pack 1 or later)/Windows Vista Ultimate (Service Pack 1 or later)/Windows 7 Starter/Windows 7 Home Basic/Windows 7 Home Premium/Windows 7 Professional/Windows 7 Ultimate Design and specifications are subject to change without notice. Other trademarks and trade names are those of their respective owners. "WALKMAN" and "WALKMAN" logo are registered trademarks of Sony Corporation. Microsoft, Windows and Windows Vista are registered trademarks of Microsoft Corporation in the United States and/or other countries. All other trademarks and registered trademarks are trademarks or registered trademarks of their respective holders. When the screen to select a connection target appears, select "MDR-NWBT10. " When the screen to enter the passkey appears, enter "0000". When pairing is established, depending on the Bluetooth device, Bluetooth connection may start automatically. note If pairing with multiple Bluetooth devices, repeat the steps from step 1 for each pairing. [. . . ] Depending on the device to be connected, it may require some time to start communication. other Do not place the Bluetooth headphones in a place exposed to humidity, dust, soot or steam, subject to direct sunlight, or in a car waiting at a traffic signal. If you experience discomfort after using the Bluetooth headphones, stop using the Bluetooth headphones immediately. Do not put weight or pressure on the Bluetooth headphones as it may cause the Bluetooth headphones to deform during long storage. [. . . ]