User manual SONY DHC-FL7D

[. . . ] Perform the following procedure 1 to 4 to hook up your system using the supplied cords and accessories. Inserting two R6 (size AA) batteries into the remote With normal use, the batteries should last for about six months. When the remote no longer operates the system, replace both batteries with new ones. If you do not use the remote for a long period of time, remove the batteries to avoid possible damage from battery leakage. [. . . ] Be careful disconnect the mains lead or move the deck before this point. Before disconnecting the mains lead, do the following: ­ Remove the MD. The MD deck starts storing audio data when the deck is in recording pause in step 3 and you start playing the source. If you press ENTER/YES on the remote within 6 seconds of this point then Time Machine Recording starts with less than 6 seconds of audio data. press ENTER/YES on the remote at the point you want to start recording. Recording of the source starts with the 6 seconds of audio data stored in the buffer memory. If you use an MD with tracks already recorded on it, the MD deck automatically locates the end of the recorded portion and starts the new recording from there. When you record from this system's CD (digital recording), the track numbers are automatically marked. In addition, you can mark track numbers: · At any point while recording. Press EDIT then press +/­ repeatedly until "LevelSync ?Marking track numbers at a specific point while recording If "LEVEL-SYNC" disappears, do step 1 through 5 to turn ON. If the MD is record protected, "MD Protected" appears in the display and the MD cannot be edited. If the MD is protected against erasure, slide the tab to close the slot. The MD editing is complete only after all the editing information is entered to TOC at which point TOC stops flashing and goes out. Be careful disconnect the mains lead or move the deck before this point. Before disconnecting the mains lead, do the following: ­ Remove the MD. If you a labeled CD on a new MD, the title is automatically recorded on the MD (Disc Memo Copy function). Press CHARACTER repeatedly until the type of character you want appears. Each time you press the button, the display changes as follows: A (Upper case) n a (Lower case) n 0 (Numbers) n !The character you selected in step 5 stops flashing and the cursor shifts to the right. Or / until the character you want to change flashes, then repeat steps 4 through 6. To erase a character, press CANCEL/NO while the character is flashing. [. . . ] MMove the system to a stable place and start recording over from the beginning The MD is dirty or is scratched or the MD does not meet the standards. MChange the MD with another one and start recording over from the beginning. c13/Disc Error The MD deck cannot read the disc information correctly. Sound comes from one channel, or the left and right volume are unbalanced. [. . . ]