User manual SONY CDX-GT434U

[. . . ] How to detach and attach the front panel Before installing the unit, detach the front panel. Press (OPEN), then slide the front panel to the right side, and pull out the left side. In the front panel onto Place the hole the spindle on the unit as illustrated, then push the left side in. [. . . ] In the front panel onto Place the hole the spindle on the unit as illustrated, then push the left side in. When installing this unit: Depending on car type, the mounting angle may not allow the front panel to open easily. When the installation and connections are completed, be sure to press the reset button with a ball-point pen, etc. Be careful not to pinch any wires between the screw and the body of the car, or this unit, or between any moving parts such as the seat railing, etc. Connect the power connecting cord 8 to the unit and speakers before connecting it to the auxiliary power connector. Connect the yellow cord to a free car circuit rated higher than the unit's fuse rating. If you connect this unit in combination with other stereo components, the car circuit they are connected to must be rated higher than the sum of the individual components' fuse rating. If there are no car circuits rated as high as the unit's fuse rating, connect the unit directly to the battery. To a car's auxiliary power connector a un conector de alimentación auxiliar del automóvil till bilens yttre strömanslutning. Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the right speaker with those of the left speaker. Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. Continuous power supply suministro de alimentación continua kontinuerlig strömförsörjning alimentação de corrente contínua power aerial control control de antena motorizada styrning av motorantenn antena eléctrica Switched power supply suministro conmutado de alimentación switchad strömförsörjning alimentação de corrente comutada ground toma de tierra jord Terra Warning when installing in a car without ACC (accessory) position on the ignition key switch Be sure to press (OFF) on the unit for two seconds to turn off the clock display after turning off the engine. When you press (OFF) only momentarily, the clock display does not turn off and this causes battery wear. Check your car's auxiliary power connector diagram to make sure the connections match correctly. You may need to switch the positions of the red and yellow leads in the car stereo's power connecting cord. [. . . ] When you press (OFF) only momentarily, the clock display does not turn off and this causes battery wear. Check your car's auxiliary power connector diagram to make sure the connections match correctly. You may need to switch the positions of the red and yellow leads in the car stereo's power connecting cord. [. . . ]