User manual SONY CDX-GT430U

[. . . ] Refer to these numbers whenever you call upon your Sony dealer regarding this product. CDX-GT430U Serial No. Do not stick paper or tape on the labeled surface. When you play 8 cm (3 in. ) CDs Do not expose the discs to direct sunlight or heat sources such as hot air-ducts, or leave them in a car parked in direct sunlight where there can be a considerable rise in temperature inside the car. Use the optional Sony compact disc single adapter (CSA-8) to protect the CD player from damage. 90° AM Tuning range Antenna terminal Intermediate frequency Sensitivity 530 ­ 1, 710 kHz External antenna connector 10. 7 MHz/450 kHz 30 µV Power amplifier section For installation and connections, see the supplied installation/connections manual. Maintenance Fuse replacement When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows again after replacement, there may be an internal malfunction. [. . . ] In such a case, consult your nearest Sony dealer. Speaker outputs (sure seal connectors) Speaker impedance 4 ­ 8 ohms Maximum power output 45 W × 4 (at 4 ohms) Outputs Before playing, clean the discs with an optional cleaning cloth. Do not use solvents such as benzine, thinner, commercially available cleaners, or antistatic spray intended for analog discs. CDX-GT430U Sony Corporation 2000 Printed in Japan Fuse (10 A) Getting Started Resetting the unit Before operating the unit for the first time or after replacing the car battery, you must reset the unit. Press the reset button with a pointed object, such as a ball-point pen. Reset button Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/ TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Welcome ! Thank you for purchasing the Sony Compact Disc Player. The sound improves, but becomes monaural ("STEREO" disappears). To return to normal mode, press again until "MONO" disappears. 2 The minute indication flashes. Press (MODE) repeatedly to select the band. Each time you press (MODE), the band changes as follows: B FM I B FM II B FM III B AM 3 Set the minute. To go forward To go backward Note If you try to store another station on the same number button, the previously stored station will be erased. ·The unit is installed at an angle of more than 60°. ·The unit is not installed in a sturdy part of the car. 3 Press (SENS/BTM) for two seconds. The unit stores stations in the order of their frequencies on the number buttons. A beep sounds when the setting is stored. Changing the display item Radio reception Problem Preset tuning is not possible. Connect an power aerial control lead (blue) or accessory power supply lead (red) to the power supply lead of a car's aerial booster. (When your car has built-in FM/AM aerial in the rear/ side glass only. ) ·Tune in the frequency accurately. t Set to the MONO mode. * Warning when installing in a car without ACC (accessory) position on the ignition key switch Be sure to press (OFF) on the unit for two seconds to turn off the clock display after turning off the engine. When you press (OFF) momentarily, the clock display does not turn off and this causes battery wear. 3 Press (DSPL). The clock starts. [. . . ] When you press (OFF) momentarily, the clock display does not turn off and this causes battery wear. 3 Press (DSPL). The clock starts. Note If the car has no accessory position on the ignition key switch, the clock cannot be set unless the power is turned on. Set the clock after you have turned on the radio, or started CD playback. Notes · The unit does not store stations with weak signals. If only a few stations can be received, some number buttons will retain their former setting. [. . . ]