User manual SONY CDX-GT28

[. . . ] Do not use solvents such as benzine, thinner, commercially available cleaners, or antistatic spray intended for analog discs. Warning 2 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/ TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Welcome ! Thank you for purchasing the Sony Compact Disc Player. This unit lets you enjoy a variety of features. Dismounting the unit 1 Insert the supplied tool between the unit and the frame, and rotate 90° to release the hidden mounting spring. Repeat on the opposite side and remove the frame. Insert a flathead screwdriver between the bracket and mounting spring. Gently pry the spring toward the unit while pulling the unit out a little. Repeat on the opposite side and remove the unit. Notes on moisture condensation On a rainy day or in a very damp area, moisture may condense on the lenses inside the CD player. In this case, remove the disc and wait for about an hour until the moisture evaporates. 10 mm (13/32 in. ) When you play 8 cm (3 in. ) CDs Use the optional Sony compact disc single adapter (CSA-8) to protect the CD player from damage. 4 mm (3/16 in. ) Notes on handling CDs A dirty or defective disc may cause sound dropouts while playing. To keep the disc clean, do not touch the surface. Maintenance Fuse replacement Do not stick paper or tape on the labeled surface. A beep sounds when the setting is stored. Changing the display item 3 Press (DSPL). The clock starts. Notes · The unit does not store stations with weak signals. If only a few stations can be received, some number buttons will retain their former setting. · When a number is indicated in the display, the unit starts storing stations from the one currently displayed. · If a CD is not in the unit, only the tuner band appears even if you press (SOURCE). Receiving the memorized stations 1 2 3 Press (SOURCE) repeatedly to select the tuner. Press the number button ((1) to (6)) on which the desired station is stored. Each time you press (DSPL), the item changes as follows: Frequency ~ Clock Troubleshooting guide CD Player Listening to a CD Insert a CD. Playback starts automatically. Label side up SEEK AMS Other Functions Locating a specific track -- Automatic Music Sensor (AMS) During CD playback, press either side of (SEEK/AMS) for each track you want to skip. To locate succeeding tracks To locate preceding tracks The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. General Problem Cause/Solution ·Adjust the volume with (+). ·Set the fader control to the center position for two-speaker systems. ·An optional power amplifier is connected and you are not using the built-in amplifier. ·The beep sound is cancelled. Adjusting the sound characteristics You can adjust the bass, treble, balance, and fader. [. . . ] ·The beep sound is cancelled. Adjusting the sound characteristics You can adjust the bass, treble, balance, and fader. Each source can store the bass and treble level independently. Attenuating the sound Press (ATT). To restore the previous volume level, press (ATT) again. No sound. The contents of the memory have been erased. No beep sound. 1 Select the item you want to adjust by pressing (SOUND) repeatedly. [. . . ]