User manual SONY CDX-GT24

[. . . ] This product contains technology subject to certain intellectual property rights of Microsoft. Use or distribution of this technology outside of this product is prohibited without the appropriate license(s) from Microsoft. Warning if your car's ignition has no ACC position Be sure to set the Auto Off function (page 17). The unit will shut off completely and automatically in the set time after the unit is turned off, which prevents battery drain. [. . . ] The tracks on the iPod start playing automatically from the point last played. If an iPod is already connected, to start playback press repeatedly until "USB" appears. Caution for iPhone When you connect an iPhone via USB, telephone volume is controlled by iPhone itself. In order to avoid sudden loud sound after a call, do not increase the volume on the unit during a telephone call. Note Do not detach the front panel during playback of the iPod, otherwise data may be damaged. You can operate an iPod directly even when connected to the dock connecter. "MODE IPOD" appears and you will be able to operate the iPod directly. Then "MODE AUDIO" will appear and the play mode will change to iPod mode. You can listen to tracks repeatedly (repeat play) or in random order (shuffle play). *1 iPod only *2 CD only *3 USB and iPod only During playback, press (REP) or (SHUF) repeatedly until the desired play mode appears. The unit enters the Quick-BrowZer mode, and the list of search categories appears. The unit can simulate a natural sound field by delaying the sound output from each speaker to suit your position. FRONT L (): Front left FRONT R (): Front right FRONT (): Center front ALL (): In the center of your car OFF: No position set "CUSTOM" of EQ7 allows you to make your own equalizer settings. Rotate the control dial until "EQ7 SETTING" appears, then press it. Rotate the control dial until "BASE" appears, then press it. You can also set the approximate subwoofer position from your listening position if: ­ the audio output is set to "SUB-OUT" (page 17). 0 kHz Rotate the control dial to adjust the volume level, then press it. Rotate the control dial until "SET POSITION" appears, then press it. Rotate the control dial to select from "FRONT L, " "FRONT R, " "FRONT" or "ALL, " then press it. Rotate the control dial until "SET SW POS" appears, then press it. Rotate the control dial to select the subwoofer position from "NEAR, " "NORMAL" or "FAR, " then press it. Rear Bass Enhancer enhances the bass sound by applying the low pass filter setting (page 17) to the rear speakers. [. . . ] Never touch the connectors directly with your fingers or with any metal device. The following checklist will help you remedy problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. For details on using the fuse and removing the unit from the dashboard, refer to the installation/connections manual supplied with this unit. [. . . ]