User manual SOLAC ECOGENIC

[. . . ] Never immerse the appliance in water or any other liquid, and do not put it in the dishwasher. Never use the robot vacuum cleaner without the dustbin or the protective filter adequately fitted. Keep hair, clothes, fingers and any other body areas away from the vacuum module, rollers and wheels. Do not use the appliance in confined spaces where explosive or toxic vapours can build up. [. . . ] Do not store or charge the appliance near radiators or other heat sources, or exposed to direct sunlight. Every few months, allow the batteries to drain completely and then recharge them. To discharge them, use the appliance in cordless mode until it stops, with the charging station switched off. When storing the appliance for a long period of time, we recommend you fully charge the battery and then remove it for storage in a cool, dry place. This appliance is intended for daily floor maintenance, avoiding the accumulation of dirt and appearance of fluff. Completely remove all the elements used for transportation and packaging. Do not use the robot vacuum cleaner between small tables, chairs or very small spaces, as this could damage the appliance. The robot vacuum cleaner uses cleaning settings to effectively clean the whole floor: Spiral movement for more intense cleaning where dirt has been detected, wall following for cleaning the perimeter of the room and room-crossing to ensure a full clean. The robot vacuum cleaner will take approximately 45 minutes to clean an average-sized room, passing over the same area several times to ensure the whole surface is cleaned. Charge button: Lights up when pressed, turns off when the robot connects to the charging station. Ultra-violet lamp: Lights up when pressed, the disinfection lamp will operate while the robot is cleaning. 1 Remove all objects that could break or damage the robot vacuum from the floor (e. CHARGING THE ROBOT VACUUM") 6 If you want to use the robot vacuum in automatic mode, programme its operation using the remote control. The robot vacuum will then start to operate, following its cleaning patterns. , If you wish, you can control its movements or functions using the remote control buttons , Press the UV key, if you want to sterilise the front area. This function is particularly recommended for people suffering from allergies and for homes with pets, as it sterilises the floor against viruses and bacteria. 9 If you do not want a programmed weekly clean, turn off the appliance after cleaning. 1B ON switch & Length of virtual barrier Off Short range = 4 m Medium range = 6 m Long range = 8 m 2B 3B 4B 5B 6B LED ON light Proximity sensor head Virtual barrier sensor head Battery compartment cover Battery cover clip , Use the virtual barrier to define the desired cleaning area, preventing the robot from Use this to prevent the robot entering areas with cables or a particular room. Place the virtual barrier at the same level on the surface where you are going to use the robot vacuum. Place the virtual barrier and the charging station at a distance of more than 3 m apart, to prevent interferences. Do not place the charging station within range of the virtual barrier's signal. The proximity sensor head (3B) prevents impact between the robot vacuum and the virtual barrier, preventing it from coming within a distance of less than 0. [. . . ] Clean the filter thoroughly if you detect a reduction in the appliance's vacuuming capacity. It is advisable to replace the filter once or twice a year, depending on how often the appliance is used. Press the semi-circular holder with one hand to remove the used filter from the holder (fig. 10) Gently shake the removed filter against the side of the rubbish bin to dislodge excess dust and dirt. [. . . ]