User manual SOLAC D212A CIRE DOUBLE CUVE

[. . . ] € Children must be supervised to ensure they do not play with the appliance. € This appliance is not to be used by persons (or children) whose physical, sensorial or mental capacities are impaired, or who have no experience or knowledge, unless supervised or instructed in the use of the appliance by a person responsible for their safety. In the event of any anomaly in the cord or any other part of the appliance, do not use it and take it to an authorised service centre. [. . . ] € Do not use any parts or accessories not supplied or recommended by SOLAC. € Before plugging the appliance into the mains, check that the indicated voltage is the same as in your home. € Always unplug the appliance after use and before assembling or removing parts, and performing any maintenance or cleaning operations. The appliance must be switched off before plugging or unplugging it into the mains • Do not use the cord to hang up the appliance. € Make sure the cord does not come into contact with sharp edges or hot surfaces. Do not leave the cord hanging over the edge of a table or worktop, to prevent children from pulling it and causing the appliance to fall. € If the power cord is damaged, it should be replaced by the manufacturer or by your after-sales service shop or similar qualified personnel to prevent possible hazards. Z Wax should always be applied in the opposite direction to the growth of the hair. As soon as it no longer sticks to the touch, press with the palm of the hand to make the skin stick, then raise the strip from the base and pull upwards with one swift movement. Z Do not wait for the wax to go cold, as it will become brittle and difficult to remove. I Remains of hair can be removed with a little alcohol or by pressing them with a ball of wax still soft. 11Place the strips of used wax in the filter in tub 2 and set tub 2’s temperature regulator to wax melting mode (Fig. 12When the wax has melted, filter it, clean, then remove the filter and place it under cold water. 13If necessary, put back the temperature regulator to the hair removal setting (Fig. [. . . ] 13If necessary, put back the temperature regulator to the hair removal setting (Fig. I You may continue hair removal by using the wax in tub 2, then placing the used strips in the filter which you have now placed into tub 1. 14After hair removal, gradually top up the wax with Solac wax capsules (REF. [. . . ]