User manual SMITH CORONA OFFICE2000CHAP2

[. . . ] (If Auto Return is activated, tabs cannot be set beyond the right margin. ) Regular Tabs 1. Type Move the Mode Selector to Type. Position the cursor to the desired tab location using Code + Code + , Spacebar, or Back Space. The symbol " T " appears on the typing scale, and a beep is heard. You can then change mode, if desired. Tab S Using Regular Tabs Press Tab (Tab C). [. . . ] Settings can be changed in Type Mode or you can change them for a specific document in Mem Mode when you recall the document. Changing a Regular Tab to a Special Tab 1. The tab will change to a Decimal Tab (DT), and the unit will beep once. NOTE: This can also be done in Mem Mode when you are recalling a saved file (see "Memory Mode"). 2-4 -- Page Layout Smith Corona Corporation Changing a Special Tab to a Regular Tab 1. NOTE: This can also be done in Mem Mode when you are recalling a saved file (see "Memory Mode"). Changing All Tabs to One Special Tab 1. Press Code + Spec Tabs (8) until all tabs on the typing scale change to the tab desired. Changing All Special Tabs to Regular Tabs 1. All Special Tabs are changed to Regular Tabs. Removing One Tab Setting 1. Position the print hammer on that tab location by pressing Tab (Tab C). One beep is heard. Clearing All Tab Settings In Type Mode, press and hold Code + Tab C (Tab) until 2 beeps are heard. The display prompts: All Tabs Clear Smith Corona Corporation Page Layout -- 2-5 Settings The Settings feature allows you to set End of Page warning, Pitch, Line Spacing, Impression Control, and the number of lines to be displayed in Mem Mode. Note that the current settings are always shown on the display in Type and Line Modes. End of Page Warning, Pitch, Line Spacing and Impression Control are all set using the display and the setting indicators printed on the unit case above it. They can be set and/or changed in any mode using the instructions below. IMPORTANT: If you change any of these settings in Mem Mode while you are creating a document, reformat the text before printing. End of Page Warning An End of Page Setting alerts you when you are approximately one inch from the bottom of the page in Type Mode and Line Mode by beeping 3 times. After you hear this warning, do not attempt to add additional lines of text. In Mem Mode, the unit will halt printing at approximately one inch from the bottom of the page for you to insert a new sheet of paper. End of Page can be set for 11" or 14" paper or can be turned off unless you are in Mem Mode. The display prompts: Set End of Page Press Spacebar until the correct setting (11", 14" or OFF) appears on the display. IMPORTANT: Do not use the platen knob to adjust the paper while using the End of Page feature. The line counter is reset each time you use Automatic Paper Insert. 2-6 -- Page Layout Smith Corona Corporation Pitch Your typewriter has been designed with triple pitch capabilities: 10 characters per inch (Pica), 12 characters per inch (Elite), and 15 characters per inch (Micro). When pitch is changed, margins and tabs may need to be adjusted because the number of characters per inch varies depending on pitch. [. . . ] Press Code + Settings (7) to activate Settings (if not already activated). Press Return until the display prompts: Set Impression Press Spacebar until the setting you want is displayed. Press Return to move to the next setting option, or press Code + Settings (7) to deactivate Settings. Copier paper, erasable bonds and very heavy textured bond papers do not print well with Correctable Film Ribbon. [. . . ]