User manual SIMRAD PI SEINESOUNDER TRAWLERS QUICK REFERENCE GUIDE REV B

[. . . ] Quick reference guide Simrad PI SeineSounder for trawlers Purpose The Simrad PI SeineSonder does two jobs at the same time. From its position on the trawl's headrope it will measure the depth from the sea surface and the height over the seabed. Daily operation A Once installed and put to use, the sensor will automatically be switched on once the waterswitch (the SHORT bolt) is activated. [. . . ] To change the sensor setup (channel selection), use the PI Configurator utility. The sensor update rate controls how often the sensor reads and reports the height. Fast: Recommended for new equipment, or if you are not familiar with the bottom conditions. System configuration The sensor must be configured with to unique sensor numbers. Select the same update rate for both, and use channel numbers according to the sensor's configuration. Set it to Level 9 if you have noise problems from other hydroacoustic sources. Note that this filters will influence the signal spectrum shown in the Status display. We recommend that you set the sensor filter to Light. Numerical presentation On the PI display, you must use two channels to receive the information from the SeineSounder. If the height or depth is increasing or decreasing, this is shown with two arrows and the variation in meters per minute. You can also see the depth and height changes as a function of time in a graphical presentation. If the height is out of range, the displays shows ???. AB (A) Sensor identification (B) Unit of measurement D1 [m] (C) Depth F (D) Depth change/ minute H (E) Arrow indicates that H1 [m] the depth is increasing (F) Visual alarm G (G) Sensor transmission indicator (H) Interference warning (I) Height (J) Height change/minute (K) Arrows pointing "out" means that the depth is increasing, arrows pointing "in" means that height is decreasing (CD012205D) C D E 43. 5 6 21. 8 1 I J K Mounting Location: Place the sensor where you wish to monitor the height. This is normally aft of the headrope at the center of the net. Ensure that you mount the sensor with the reverse side (D) and the echo sounder transducer (E) pointing towards the bottom! [. . . ] The sensor must be properly secured to prevent it from moving sideways or rotate during use. Make sure that you have best possible free view between the sensor and the bottom, and between the sensor and the vessel. NOTE! (CD012207C) E D For bottom and pelagic trawl applications, use the SHORT key bolt! 313699 / Rev. B / October 2007 Simrad Kongsberg Maritime AS Strandpromenaden 50 P. O. Box 111 N-3191 Horten, Norway Telephone: +47 33 03 40 00 Telefax: +47 33 04 29 87 www. simrad. com simrad. sales@simrad. com [. . . ]