User manual SIEMENS WAQ2446KBY

[. . . ] Covers Elbow for fixing the drainage hose in place Adapter 1/2''-3/4'' (depending on model) Aqua Stop, Aqua-Secure 2. Remove all 4 transport braces completely and take the mains cable out of the holders (depending on model). 90° Standard Aqua-Secure, Standard Installation on a pedestal ­ The feet of the washing machine must be secured with holding brackets*. WMZ20455, WZ20455 Installation on a wood joist floor ­ If possible, place the washing machine in a corner. [. . . ] If a fault in our Aqua-Stop system causes water damage, we will reimburse damages caused to private customers. The liability guarantee is valid for the service life of the appliance. It is a prerequisite of all warranty claims that the appliance with Aqua-Stop must have been set up and connected correctly in accordance with our instructions; this also includes a correctly fitted Aqua-Stop extension (original accessories). Our warranty goes not cover defective power cables or fittings between the Aqua-Stop connection and the tap. Appliances with Aqua-Stop do not need to be supervised during operation, nor secured afterwards by turning off the tap. The tap only needs to be turned off if you are away from home for a long period, e. g. 60 x 55 x 85 cm 66 ­ 73 kg depending on model Nominal voltage 220-240 V, 50 Hz Nominal current 10 A Nominal power 2, 300 W 200-1000 kPa (2-10 bar) Installation instructions en Electrical connection The washing machine must only be connected to an alternating current via a properly installed earthed socket. After transportation, the transport braces must be removed. page 3. Contents Safety instructions . . To prevent unused detergent from flowing straight into the drain during the next wash: Pour 2 litres of water into compartment II and start the Empty programme. 9000502633 The power supply and voltage indicated on the washing machine (rating plate) must be the same. The connected load and fuse required are specified on the rating plate. Make sure that: ­ the mains plug fits the socket, ­ the cable cross-section is adequate, ­ the earthing system is properly installed. (If this is necessary), the mains cable may only be replaced by a qualified electrician. If a residual current circuit breaker is used, only use a type which displays this symbol: , . Only this symbol guarantees compliance with the currently applicable regulations. Pull the appliance plug out of the socket at the plug only, not by the cable. Technical specifications Dimensions (width x depth x height) Weight Mains connection Page . . 7 9008 / 9000502633 Water pressure Read these instructions before switching on the washing machine. Keep all documents for use in the future or for the subsequent owner. Manufacturer ­> Operating instructions 5 6 7 Safety instructions ­ The washing machine is heavy - take care when lifting. Do not install the washing machine in areas exposed to frost or outdoors. the washing machine door, the cover, the front panel or the outer door in case of deco models). ­ In addition to the instructions provided in this document, special regulations from the relevant water and electric utility companies may apply. ­ Lay hoses and cables in such a way that there is no risk of tripping. Scope of delivery depending on model Aqua Stop Aqua Secure & Standard Hot water Moisture inside the drum is due to final testing. Mains cable Water outlet Water inlet Installation surface ­ The machine must be stable so that it does not move around. Covers Elbow for fixing the drainage hose in place Adapter 1/2''-3/4'' (depending on model) Installation on a pedestal ­ The feet of the washing machine must be secured with holding brackets*. WMZ20455, WZ20455 Installation on a wood joist floor ­ If possible, place the washing machine in a corner. [. . . ] This will ensure that the repair is carried out by trained service technicians who arrive equipped with genuine spare parts for your appliance. Aqua-Stop warranty only for appliances with Aqua-Stop In addition to warranty claims against the vendor from the purchase agreement and to our appliance warranty, we will pay damages under the following conditions: 1. If a fault in our Aqua-Stop system causes water damage, we will reimburse damages caused to private customers. The liability guarantee is valid for the service life of the appliance. It is a prerequisite of all warranty claims that the appliance with Aqua-Stop must have been set up and connected correctly in accordance with our instructions; this also includes a correctly fitted Aqua-Stop extension (original accessories). [. . . ]