User manual SIEMENS HW1405P2B/06 INSTALLATION INSTRUCTIONS

[. . . ] Be aware of the technical conditions in your particular environment, e. Do not hold the rear of the handset to your ear when it is ringing or when the handsfree function is activated. Do not install the base station or charging cradle in bathrooms or shower rooms. Do not use your phone in environments with a potential explosion hazard (e. [. . . ] If you have no CallerID (CLIP) service but wish to see the number or the name of a caller, press the left display key AON (it appears some seconds after you have started a call) and you will see the caller's number if identification is successful. (¢ page 29), the handset will automatically accept a call when you lift it out of the cradle. Please note that to display the caller's phone number or name (see next section), the display key §AOH§ must be pressed before the call is accepted. to deactivate the ringer , press the §Silence§ display key. In handsfree mode, instead of holding the handset to your ear you can put it down, for example on the table in front of you. If you do not have the CLIP service, External is displayed instead of the number: u If no number is transmitted. If you have the CLIP service, the following is displayed in place of the number: u External, if no number is transmitted. u Withheld , if the caller has not arranged Calling Line Identification. You should inform your caller before you use the handsfree function so that they know someone else is listening. If you wish to place the handset in the charging cradle during a call: ¤ Press and hold the handsfree key d while placing the handset in the base station. You can deactivate the microphone in your handset during an external call. The room monitor call to an internal number (handset) is terminated after approximately 3 minutes (depending on the base station). When the room monitor is activated, all keys except the end call key are locked. When the room monitor is activated, incoming calls to the handset are indicated without a ringer and are only shown on the screen. The display and keypad are not illuminated and advisory tones are also turned off. Using a handset as a room monitor If you accept an incoming call, the room monitor is suspended for the duration of the call, but the function remains activated. If you deactivate then reactivate the handset, the room monitor remains activated. Check the connection if you are diverting the room monitor to an external number. U Ideally the handset should be positioned 1 to 2 metres away from the baby. U The connection to which the room monitor is diverted must not be blocked by an activated answering machine. ¤ Enter number as described in "Activating the room monitor and entering the destination number" (¢ page 27). ¤ Enter number as described in "Activating the room monitor and entering the destination number" (¢ page 27). [. . . ] We, Gigaset Communications GmbH, declare that this device meets the essential requirements and other relevant regulations laid down in Directive 1999/5/EC. A copy of the 1999/5/EC Declaration of Conformity is available at this Internet address: www. We, Gigaset Communications GmbH, carry social responsibility and are actively committed to a better world. Our ideas, technologies and actions serve people, society and the environment. [. . . ]