User manual SIEMENS GIGASET S680

[. . . ] s Issued by Gigaset Communications GmbH Schlavenhorst 66, D-46395 Bocholt Gigaset Communications GmbH is a trademark licensee of Siemens AG Gigaset Communications GmbH 2008 All rights reserved. www. gigaset. com Gigaset S680 Gigaset Handset at a glance Handset at a glance 18 17 16 V 1 2 INT 1 15. 11. 07 ?09:45 SMS 3 4 5 15 14 13 12 11 10 9 8 6 7 The base station at a glance 1 Display (screen) in idle status 2 Charge status of the batteries = e V U (flat to full) = flashes: batteries almost flat e V U flashes: batteries charging 3 Display keys (page 10) 4 Message key Access to calls and message lists; Flashes: new message or new call 5 End call key, On/Off key End call, cancel function, go back one menu level (press briefly), back to idle status (press and hold), activate/deactivate handset (press and hold in idle status) 6 Hash key Keypad lock on/off (press and hold in idle status), Toggle between upper/lower case and digits (press and hold) 7 Call-by-call list key Open call-by-call list 8 Microphone 9 Recall key - Confer (flash) - Insert a dialling pause (press and hold) 10 Star key Ringer tones on/off (press and hold); With an open connection: switch between dial pulsing/touch tone dialling (press briefly) Open special characters table 11 Key 1 Dial network mailbox (press and hold) 12 Connection socket for headset 13 Talk key Answer a call, open last number redial list (press briefly), start dialling (press and hold) When writing an SMS: send SMS 14 Handsfree key Switch between earpiece and handsfree mode; Lights up: handsfree activated; Flashes: incoming call 15 Control key (page 10) 16 Bluetooth activated (page 47) 17 Eco mode activated (page 12) 18 Signal strength i (high to low) | flashes: no reception Registration/paging key (page 35) 1 Contents Contents Handset at a glance . 35 36 36 36 36 37 38 38 38 Making calls easily using network services . [. . . ] Press the display key. Deleting an info service Then: Select the info service (see above). Options Open menu. Select and press OK. Delete Entry Activating/deactivating the SMS function If you deactivate the SMS function, you cannot send or receive any SMS messages with your phone. The settings which you have made for sending and receiving SMS messages (e. g. the call numbers of the SMS centres) and the entries in the incoming and draft message lists are saved even after you turn off your phone. Q OK Or: OK Activate SMS function (default setting). 32 SMS (text messages) SMS troubleshooting Error codes when sending E0 Calling Line Identification permanently withheld (CLIR) or Calling Line Identification not activated. FD Connection to SMS centre failed, see selfhelp. The message is played back. Ask your service provider to activate this function (chargeable). 2. Your mobile phone operator and your fixed network SMS service provider have not agreed on a co-operation. Your terminal is recorded by your SMS provider as having no fixed network SMS functionality, i. e. Have the device (re-)registered to receive SMS messages. Self-help with errors The following table lists error situations and possible causes and provides notes on troubleshooting. You cannot send messages. You have not requested the CLIP service (Calling Line Identification Presentation). Ask your service provider to enable this service. Messages are only received during the day. The terminal is recorded in your SMS provider's database as having no fixed network SMS functionality, i. e. No number or an invalid number is entered for the SMS centre set as the active send service centre. Enter the number (page 31). You receive an incomplete SMS. Give your SMS contacts your new ID or undo the change (page 31). 2. Call diversion is activated with When: All Calls or the All Calls call diversion is activated for the network mailbox. Change the call diversion 33 Using the network mailbox Using the network mailbox The network mailbox is your network provider's answer machine within the network. You cannot use the network mailbox unless you have requested it from your network provider. Calling the network mailbox d Press and hold. You will hear the network mailbox announcement. Configuring fast access for the network mailbox With fast access, you can dial the network mailbox directly. You only need to enter the number of the network mailbox. Viewing the network mailbox report When a message is recorded, you receive a call from the network mailbox. If you have requested Calling Line Identification, the network mailbox number will be displayed. [. . . ] This is illustrated below using the example of "Setting the date and time". You will see the following display (example): Date/Time Date: [15. 11. 2007] Time: 11:11 Writing and editing text The following rules apply when writing a text: u Control the cursor with u v t s. Select the required character, press the display key Insert to insert the character at the cursor position. u The first letter of the name of directory entries is automatically capitalised, followed by lower case letters. Writing an SMS/name (without predictive text) Save Press the relevant key several times to enter letters/characters. Date: Enter the day, month and year in 8-digit format. [. . . ]