User manual SIEMENS GIGASET E450

[. . . ] s Issued by Gigaset Communications GmbH Schlavenhorst 66, D-46395 Bocholt Gigaset Communications GmbH is a trademark licensee of Siemens AG Gigaset Communications GmbH 2008 All rights reserved. www. gigaset. com Gigaset E450 Handset at a glance 1 16 INT 1 10. 05. 05 INT 09:45 SMS V 2 3 15 14 13 12 4 5 11 10 9 6 7 8 Base station at a glance 1 Display in idle status 2 Battery pack charge status = e V U (flat to full) = flashes: battery pack almost flat e V U flashes: battery pack charging 3 Display keys (page 13) 4 Message key Access to calls and message lists; Flashes: new message or new call. 5 End call key, On/Off key End call, cancel function, go back one menu level (press briefly), back to idle status (press and hold), activate/deactivate handset (press and hold in idle status) 6 Hash key Key lock on/off (press and hold in idle status), Toggle between upper/lower case and digits 7 Call-by-call list key Open call-by-call list 8 Connection socket for headset 9 Microphone 10 Recall key - Confer (Flash) - Insert a dialling pause (press and hold) 11 Star key Ringtones on/off (press and hold), Open table of special characters 12 Key 1 Select network mailbox (press and hold) 13 Talk key Answer a call, open last number redial list (press briefly), start dialling (press and hold) 14 Handsfree key Switch between earpiece and handsfree mode; Lights up: handsfree activated; Flashes: incoming call 15 Control key (page 13) 16 Signal strength i (high to low) | flashes: no reception Registration/Paging key (page 31/page 31) 1 Contents Contents Safety precautions . 31 31 31 32 32 33 33 33 34 35 35 35 36 36 36 37 37 38 38 39 Operating the handset . [. . . ] You can tell that this is supported by the fact that a star (*) is added to the number of a (preset) SMS centre. u If you have forgotten your mailbox PIN, you can reset it by restoring the base station's factory settings. This will delete all messages from all mailboxes. 26 SMS (text messages) Setting up and changing a personal mailbox v Settings SMS Mailboxes s Select a mail box, e. g. They are shown in the SMS list and can, if necessary, be displayed by pressing the message key f. Setting up a personal mailbox v Settings SMS Mailboxes s (Select mailbox) ~ Enter mailbox PIN if necessary und press OK. Set ID:, Protection: and PIN (page 27). Changing a mailbox's PIN and ID Sending a text message to a personal mailbox To send a text message to a personal mailbox, the sender must know your ID and enter it after your number. Your SMS contact will receive your SMS number with current ID and can save it in their directory. If the ID is invalid, the SMS will not be delivered. Setting SMS centre Entering/changing SMS centres Deactivating a mailbox Set On/Off: to Off . All SMS saved in this mailbox will be deleted. Deactivating PIN protection The mailbox PIN is reset to "0000". Set Protection: to Off . Changing the name of a mailbox v Settings SMS Mailboxes s (Select mailbox) Edit Press the display key. a Press and hold (idle status). and special functions offered by your service provider before you make a new application and/or before you delete pre-configured call numbers. Change multiple line input: Active Send: Select Yes if the text messages are to be sent via the SMS centre. Enter the number of the SMS service and insert a star if your service provider supports personal mailboxes. 27 You should find out about the services SMS (text messages) Save changes (page 46). Note: Ask your service provider for details of how you should enter service numbers if you wish to use personal mailboxes (requirement: your service provider supports this function). Changing the entry of an info service View Edit Select info service (see above). 1. Activate the SMS centre (2 to 4) as send Press the display key. Press the display key. Deleting an info service Options Select info service (see above). Delete Entry Select and press OK. SMS to a PABX Calling Line Identification is forwarded to the extension of the PABX (CLIP). The CLIP of the phone number for the SMS centre is evaluated in your Gigaset. u If required, you must prefix the number for the SMS centre with the access code (depending on your PABX). by sending a text message to your own number: once with and once without the access code. u When you send SMS messages, your sender number may be sent without your extension number. Sending and receiving SMS on ISDN PABXs is only possible via the MSN number assigned to your base station. u You can only receive a SMS when the SMS info services You can have your service provider send you certain information (e. g. You can obtain information about the info services available and their costs from your service provider. Setting up/ordering an info service v SMS Service s Select info service. Send Press the display key. Ordering an info service Setting up an info service View Edit Select info service (see above). [. . . ] Press the OK display key to confirm the selection With the handset in idle status, press v Display Contrast Press the bottom of the control key selection Select and press OK. Press the OK display key to confirm the r Select contrast and press OK. repeatedly until Contrast is selected. Press on the right or left of the control key to select the contrast. Press the Save display key to confirm the selection a Press and hold the end call key until the handset returns to idle status. 45 Press and hold (idle status). Notes on the operating instructions Example: multiple line input There are many situations in which you can change the settings of a display or enter data in several lines. In this user guide symbols are used to guide you step by step through multiple line input. [. . . ]