User manual SIEMENS GIGASET C47H

[. . . ] s Issued by Gigaset Communications GmbH Schlavenhorst 66, D-46395 Bocholt Gigaset Communications GmbH is a trademark licensee of Siemens AG Gigaset Communications GmbH 2008 All rights reserved. www. gigaset. com Gigaset C47H Gigaset The handset at a glance The handset at a glance 16 INT 1 15. 11. 07 INT V 1 2 09:45 SMS 3 4 5 15 14 13 12 11 10 9 8 6 7 Please note: Illustration of handset on a base station with SMS functionality. 1 Display (screen) in idle status 2 Charge status of the batteries = e V U (flat to full) = flashes: batteries are almost flat e V U flashes: battery charging 3 Display keys (page 9) 4 Message key Access to calls and message lists; Flashes: new message or new call 5 End call key, On/Off key End call, cancel function, go back one menu level (press briefly), back to idle status (press and hold), activate/deactivate handset (press and hold in idle status) 6 Hash key Keypad lock on/off (press and hold in idle status); Toggle between upper/lower case and digits (press and hold) 7 Call-by-call list key Open call-by-call list 8 Microphone 9 Recall key - Confer (flash) - Insert a dialling pause (press and hold) 10 Star key Ringer tones on/off (press and hold); With an open connection: switch between dial pulsing/touch tone dialling (press briefly); Open special characters table 11 Connection socket for headset 12 Key 1 Dial network mailbox (press and hold) 13 Talk key Accept a call, open last number redial list (press briefly), start dialling (press and hold); When writing an SMS: send SMS 14 Handsfree key Switch between earpiece and handsfree mode; Lights up: handsfree activated Flashes: incoming call 15 Control key (page 8) 16 Signal strength i (high to low) | flashes: no reception 1 Contents Contents The handset at a glance . 16 16 17 17 17 17 18 18 19 19 20 20 20 21 21 22 22 23 24 Operating the handset . 15 2 Safety precautions Safety precautions Warning: Read the safety precautions and the user guide before use. [. . . ] If you accept an incoming call, the room monitor mode is suspended for the duration of the call, but the function remains activated. If you deactivate then reactivate the handset, the room monitor mode remains activated. v Room Monitor Change multiple line input: Room M. : Select On to activate. Internal number: INT s (Select handset or Call All if all registered handsets are to be called) OK. Save the changes. Activating the room monitor and entering the destination number Warning! You should always check the operation of the room monitor before use. Check the connection if you are diverting the room monitor to an outside number. When the function is switched on, the handset's operating time is severely reduced. Ideally the handset should be positioned 1 to 2 metres away from the baby. The connection to which the room monitor is diverted must not be blocked by an activated answer machine. v Room Monitor s Scroll to the Call to: line. Enter number as described in "Activating the room monitor and entering the destination number" (page 15). Save the changes. Editing a set external destination number v Room Monitor s Scroll to the Call to: line. Enter number as described in "Activating the room monitor and entering the destination number" (page 15). 15 Editing a set internal destination number Setting the handset Deactivating the room monitor remotely Preconditions: The phone must support touch tone dialling and the room monitor should be set for an external destination number. no ringer tone) on the handset will remain activated until you press the display key OFF on the handset. To reactivate the room function with the same phone number: Turn on the activation again and save with Save. SMS Service Assign key with the menu for ordering info services (depending on base station). Assign key with the menu for activating SMS notification (depending on base station). If a function or number has already been assigned to the left display key, the selected function (or its abbreviation) will be displayed in the lowest display line above the display key. Starting a function With the handset in idle status, press the display key briefly. The function menu is opened. Setting the handset Your handset is preconfigured, but you can change the settings to suit your individual requirements. Changing the display language You can view the display texts in different languages. s Select a language and press OK. Quick access to functions The display keys have preset functions. To start the function, you then simply need to press the button. a Press and hold (idle status). Changing a display key assignment key. SMS Assign key with the menu for SMS functions (depending on base station). Press and hold the left or right display If you accidentally choose a language you do not understand: v 5 4 Press keys in sequence. s Select the correct language and press OK. 16 Setting the handset Setting the display You have a choice of four colour schemes and several different contrasts. a Press and hold (idle status). v Display Screen Picture s Scroll to the Selection line. [. . . ] u The above provisions does not imply a change in the burden of proof to the detriment of the customer. To invoke this Guarantee, please contact the Gigaset Communications helpdesk on 1850 777 277. This number is also to be found in the accompanying user guide. 23 Appendix Specifications Recommended batteries Technology: Nickel-metal-hydride (NiMH) Size: AAA (Micro, HR03) Voltage: 1. 2 V Capacity: 6001200 mAh We recommend the following battery types, because these are the only ones that guarantee the specified operating times, full functionality and long service life: u Sanyo Twicell 650 u Sanyo Twicell 700 u Panasonic 700 mAh "for DECT" u GP 700mAh u Yuasa AAA Phone 700 u Varta Phone Power AAA 700mAh u GP 850 mAh u Sanyo NiMH 800 u Yuasa AAA 800 The device is supplied with two recommended batteries. Handset operating times/charging times The operating time of your Gigaset depends on the age of the batteries and the way they are used. (All times are maximum possible times and apply when the display backlight is switched off. ) Capacity (mAh) approx. [. . . ]