User manual SIEMENS GIGASET AL14H

[. . . ] The appropriate disposal and separate collection of used equipment serve to prevent potential harm to the environment and to health. They are a precondition for the re-use and recycling of used electrical and electronic equipment. For further information on disposing of your used equipment, please contact your local authority, your refuse collection service or the dealer you purchased the product from. [. . . ] Only place the handset in the charging cradle that is intended for it. * Gigaset Communications GmbH is a trademark licensee of Siemens AG. Place the battery leads in the lead guides so 3 On the handset ¢ ¢ ¢ PIN (default setting: 0000) ¢ OK. Registering flashes in the display. MENU Settings OK Handset OK Register HS Enter the base station system ¢ ¢ ¢ Making calls Making external calls and ending calls External calls are calls using the public telephone network. (Or you can first press and hold c [dial tone] and then enter the number. ) During the call you can adjust the earpiece volume using t. You can automatically insert a network provider dialling code before any phone number (see "Preselection" Menu tree, page 7). Registration takes approx. Please note: You can also automatically register the Gigaset AL13H handset to the Gigaset AL130/AL135 base station. Place the handset in the charging cradle of the base station with its display facing forward. Leave the handset in the base station until it is registered. ¢c. Charging the battery pack Plug the mains unit for the charging cradle into the socket and place the handset in the charging cradle with the display facing forward. To charge the battery pack, leave the handset in the base station for approx. The charge status of the battery pack is only correctly displayed after uninterrupted charging/discharging. After a while its charge capacity will decrease for technical reasons. You must set the date and time to ensure that the times of calls are logged correctly (see Menu tree page 7). Once the phone is registered and the time set, the idle display looks as shown on page 1. If you have any questions about using your phone, please read the tips on troubleshooting ("Questions and answers", page 6) or contact our customer service department (page 6). Accepting a call The handset indicates an incoming call by ringing and by a display on the screen. When Auto Answer is activated (see Menu tree, page 7), simply remove the handset from the base station/charging cradle. Using the directory and lists Directory To open the directory: press h. Please note: You can assign a number from the directory to a key for quick dialling (page 4). Saving the first number in the directory h ¢ New Entry?Enter name and press OK. Activating/deactivating the handset Press and hold the end call key a. If you place a deactivated handset into the charging cradle, it will automatically activate itself. Storing a number in the directory h ¢ MENU ¢ New Entry ¢ OK ~ ~ Enter number and press OK. Enter name and press OK. 4 ing options: Use u to scroll through the entries until the required name is selected. Enter the first character of the name and scroll to the entry with u, if required. Selecting a directory entry Open the directory with h. [. . . ] MENU Settings OK Handset OK Reset Handset OK ¢ ¢ Cancel the reset with a. ¢ ¢ ¢ ¢ General specifications DECT standard GAP standard Range Base station power supply Environmental conditions in operation is supported is supported up to 300 m outdoors, up to 50 m indoors 230 V ~/50 Hz +5° C to +45 °C; 20% to 75% humidity 6 Care Wipe down the base station and handset with a damp cloth (no solvents) or an antistatic cloth. This can cause a build up of static. Service (Customer Care) We offer you support that is fast and tailored to your specific needs!Our Online Support on the Internet: www. gigaset. com/customercare For more information on aftersales service, please refer to your local warranty card. [. . . ]