User manual SIEMENS GIGASET 5040

[. . . ] Never expose the telephone to sources of heat, direct sunlight or other electrical devices. Protect your telephone from moisture, dust, corrosive liquids and vapours. If you give your Gigaset 5040 to someone else, make sure you also give them the user guide. Easy to recognise incoming and missed calls The Gigaset 5040 also indicates visually when you receive a call: The Name key flashes if the caller is stored (see page 4). [. . . ] (You can leave the last number redial list at any time by pressing Using the Down/Up key, scroll through the list to the desired number. Using Name keys You can store up to 6 phone numbers via Name keys and label the keys with the corresponding names. Answering a call via a Name key A Name key flashes when a call comes in from the stored phone number. Prerequisite: Proximity sensor and automatic call pickup are activated (see "Activating/deactivating the proximity sensor" on page 5) and "Activating/deactivating automatic call pick-up" on page 5). Note: An automatically answered call is ended like any other call in handsfree mode (see page 4). If automatic call pick-up is not activated: After an incorrect entry, simply replace the handset if it is off the hook or pick it up if it is on the hook. The proximity sensor recognises when someone approaches the telephone and automatically activates the display and key lighting. Hold down the Proximity sensor key to activate/deactivate the function. Press the Name key if the caller is stored and the Name key is flashing. An incoming call from a number stored under one of the Name keys is automatically answered via the handsfree function when someone approaches the telephone. Prerequisite: the proximity sensor is activated and the number is stored correctly (including area code) under the name key (see page 4). Note: An automatically answered call is ended like any other call in handsfree mode (see page 4). Hold down the Automatic call pick-up key to activate/deactivate the function. When the automatic call pick-up function is activated, the symbol for the proximity sensor (OE) flashes in the display. Returning a call via a Name key A Name key is lit up if a call from the stored phone number came in. The volume of the ringer can be set to one of 4 levels and can also be deactivated completely (default setting: level 4). If the ringtone is deactivated, you can only recognise incoming calls from the display and the flashing Calls list key. To adjust when the telephone is idle: Changed telephone settings must be completed by to make them available holding down the Set key permanently. En To adjust while the telephone is ringing: Press before lifting the handset. The frequency (speed) of the ringer can be set to one of three levels (default setting: level 3). While in handsfree mode, you can set the volume to one of 7 levels and save it (default setting: 1). Ten different ringtones can be set for the ringer (default setting: ringtone 9). [. . . ] To clean, wipe with a moist or antistatic cloth only, never with a dry cloth (risk of electrostatic charging and discharge) or harsh cleaning agent. We, Gigaset Communications GmbH, declare that this device meets the essential requirements and other relevant regulations laid down in Directive 1999/5/EC. A copy of the 1999/5/EC Declaration of Conformity is available at this Internet address: www. If your telephone is not working properly no signal tone: The tone volume might be set to 0. [. . . ]