User manual SIEMENS GIGASET A39H

[. . . ] The appropriate disposal and separate collection of used equipment serve to prevent potential harm to the environment and to health. They are a precondition for the re-use and recycling of used electrical and electronic equipment. For further information on disposing of your used equipment, please contact your local authority, your refuse collection service or the dealer you purchased the product from. Emergency numbers cannot be dialled if the keypad lock (¢ page 1) is activated! [. . . ] You must activate manual registration of the handset on both the handset and the base station. The following is displayed after succesful registration: If more than one handset is registered, the internal number of the handset is shown in the upper left corner. The correct charge level can only be displayed if the batteries are first fully charged and discharged. ¤ Then remove the handset from the base station or charging cradle and do not replace it until the batteries are completely discharged. After the first battery charge and discharge you may replace your handset Always repeat the charging and discharging procedure if you remove the The batteries may warm up during charging. Warning Please ensure that the handset is in the charging cradle if you are absent for a long time (e. After the initial charging procedure a complete charging to full capacity takes at least 18 hours. Set the date and time so that the correct date and time can be assigned to incoming calls, and so that the alarm can be used. MENU Settings OK Date/Time OK Date: ~ (enter the day, month and year in 6-digit format) OK Time: ~ (enter hours and minutes in 4-digit format) OK a (press to return to idle status) Please note When entering the time and date, you can move the position of an entry to the left or right by pressing the control button up or down. Once the phone is registered and the time set, the idle display is shown as in this example. If more than one handset is registered, the internal number of the handset is shown in the upper left corner. If you have any questions about using your phone, please read the tips on troublepage 12) or contact our Customer Care shooting ("Questions and answers" team page 13. Making external calls and ending calls External calls are calls using the public telephone network. (Or you can first press and hold c to hear the dial tone and then enter the number. ) During the call you can adjust the earpiece volume using t and set the volume with u. Press the Mute key m during the call to activate/deactivate the function. Activating while dialling: Enter the number ~ and press the handsfree key d. Switching between earpiece and handsfree mode: During a call and press the handsfree key d to activate or deactivate handsfree talking. During a call, use t to activate the menu for setting the handsfree volume and use u to set the volume. The handset indicates an incoming call by ringing and by a display on the screen. When Auto Answer is activated (see Menu page 14), simply remove the handtree set from the base station/charging cradle. In idle state, use t to activate the menu for setting the call volume and use u to set the volume. [. . . ] Press the end call key a to divert the call, or press the " display key to reconnect to the external participant. If you accidentally choose a language you do not understand, press Select another language with u and press OK. When the alarm clock rings, press any key to switch it off for 24 hours. Briefly press the hash key # to switch from "Abc" to "123" mode, from "123" to "abc"mode and from "abc" to "Abc" mode. [. . . ]