User manual SIEMENS 1W090Z

[. . . ] J Safety in use is only guaranteed if the technical installation of the hob has been carried out correctly and in accordance with the installation instructions. The installation technician shall be liable for any damage caused as a result of incorrect installation. The guidelines set out by the local electricity provider must be observed. [. . . ] J A strip of wood can be used as an intermediate support or an appropriate accessory can be obtained from our After-Sales Service. The reference code for this accessory is: - 680502 for appliances with induction hotplates. J Any change to the appliance's interior, including changing the power cable, must be performed by the Technical Assistance Service. Ensure this is the case, the dimensions of the panel must be adjusted to fit the measurements of the kitchen unit housing in which the hob will be installed. For granite or marble work surfaces: Place pins or bushes for the securing screws or stick on rails. Do this using temperature resistant glue suitable for fixing metal onto stone. Remove any shavings, as these can affect the operation of the electrical components. When the cutting has been completed, the unit's stability should be checked again. J Surfaces which have been cut should be sealed so that they are heat resistant and so that they do not swell when moist. J The kitchen units to be fitted must resist temperatures of up to 90ºC. J The gap between the aperture and the side wall must be at least: 40 mm, for appliances with induction hobs; 70 mm, for mixed appliances. It is not recommended that the hob be placed between two side walls but, if this is the case, a gap of at least 200 mm should also be left on one side. J The worktop where the hob is installed should be: 30 mm thick, if it is installed above an oven, 20 mm thick, if it is installed without an oven or above a drawer. J Taking into account the hob ventilation: - an aperture must be cut in the top section of the back of the kitchen unit, 550 mm wide and 45 mm high (figure 2). - there must be a gap of 20 mm between the back of the kitchen unit and the kitchen wall (figure 4). - if the hob is installed above a drawer, allow a gap of 65 mm between the drawer and the top section of the hob. [. . . ] J Do not trap the lead during installation and do not guide it over sharp edges. J The hob and the worktop should not be sealed with silicone, as the hob itself has a seal which serves this function. Brown Black Blue White Yellow and green Dessutom måste denna kabel vara längre än alla andra kablar så att den inte av misstag rycks ut innan de andra kablarna avskiljs från elnätet, till exempel om någon skulle råka putta till hällen. [. . . ]