User manual SHIMANO TL-S703

[. . . ] SI-7080A-002-00 General Safety Information WARNING When changing the oil, be careful that no oil gets on the disc brake rotor, brake pads, on the rim when using rim brakes, etc. If oil gets on any of these parts, there is a danger that brake performance may be reduced. Take care of this problem according to the procedures in the brake instruction manual. [. . . ] Pull the piston out slowly to draw out the oil inside the hub shell. 3. Push the piston to inject the new oil into the inside of the hub. Piston Oil port Cautions regarding handling of SG-S700 Oil Use safety glasses when handling, and avoid contact with eyes. In the event of eye contact, flush with fresh water and seek medical assistance immediately. If skin condition becomes abnormal, seek medical assistance immediately. Make the affected person drink 1 to 2 cups of water and seek medical assistance immediately. If the affected person loses consciousness, do not give the person anything by their mouth. When storing, close the container tightly to prevent water or foreign materials from entering. Do not store in areas subject to direct sunlight, areas subject to temperatures above 40ºC, areas subject to water or high humidity where rust is likely to occur, or in areas where there is a risk of freezing. Dispose of used oil, old oil, or oil used for cleaning in accordance with applicable local laws and regulations. To maintain product performance, oil should be changed after the first 1, 000 km from start of use of the product, and once every 2 years thereafter (after every 5, 000 km if bicycle is ridden frequently). Use of other oils may cause problems such as oil leakage, faulty operation of speed changer, etc. When using a 1L can of oil, it may become impossible to suck out oil with a syringe when there is only a little oil left. Read these instructions carefully, and keep them in a safe place for later reference. Note: If the piston is pulled out quickly, air is likely to be mixed in. 2. Remove the oil port bolt and O ring. 3 mm Allen wrench Piston * When the oil is forced in, the internal pressure will increase and the piston may push back. If the piston is periodically pulled back to reduce the pressure inside the hub, the oil will be easier to inject into the inside of the hub. Note: Be careful that the oil port is facing up. If the oil port bolt is loosened when it is not facing up, the oil inside may leak out. Oil port bolt 4. [. . . ] (English) Syringe, Tube, Bleed nipple, O ring, Container One Holland, Irvine, California 92618, U. S. A. Phone: +1-949-951-5003 Industrieweg 24, 8071 CT Nunspeet, The Netherlands Phone: +31-341-272222 SHIMANO AMERICAN CORPORATION SHIMANO EUROPE B. V. SHIMANO INC. 3-77 Oimatsu-cho, Sakai-ku, Sakai-shi, Osaka 590-8577, Japan © Jan. [. . . ]