User manual SCOTT VOLTAGE FREERIDE

[. . . ] Recommended Tools for the Shock Set-Up Set-Up Voltage FR Basic Set-Up of Rebound Set-Up of other shock models IDS Drop Out System Front Fork Set-Up/Change of Front Fork Pivot Maintenance Warranty P. 014 2 2011 SCOTT BIKE OWNERS MANUAL VOLTAGE FR CONCEPT Voltage FR is the result of 3 years of research and development searching for one of the most versatile and durable FR and slopestyle bikes available on the market, but still easy in set-up and maintenance. [. . . ] Turn the screw 1-2 "clicks" clockwise If it does not bounce the rebound is too slow. VOLTAGE FR 11 ENGLISH Please refer to the following instruction: We recommend following coil springs: Weight (kg) 50 - 60 60 - 70 70 - 80 80 - 90 Recommended coilsprings 200 x 3. 25 250 x 3. 25 300 x 3. 25 350 x 3. 25 Important: After a dismantlement of the rear shock, both fixing bolts should be tightened with a tightening torque of 35Nm/308in-lbs. If this is not done correctly the rear shock can be damaged. For fine tuning the SAG and the corresponding eye-to-eye distance of the shock bolts you can tighten or release the pretension of the coil spring but please respect the maximum and minimum spring indications of the shock manufacturer. The eye-to-eye distance between the shock bolts should be in basic set up with 40% SAG. This length is also indicated on the cover of this manual by the colored beam of the SAG-Boy. For further details on the shock set-up please follow the indications of the rear shock manufacturer attached to this bike. Important!Note that you have to mount the rear shock always as shown underneath. Mounting the rear shock in a different position can cause severe damages to the frame, the linkage levers and the rear shock. E E2 ht ng kle oc Sh 10 2011 SCOTT BIKE OWNERS MANUAL SET-UP OF OTHER SHOCK MODELS Scottstronglyrecommendsusingonlytheoriginallyspecifiedshockwiththe VoltageFRbike, as we have chosen carefully both parts for a perfect matching combination. VOLTAGE FR If you want to use a different rear shock model than the one originally on the bike, please make sure that the shock will not in any position hit the frame and cause a damage to the frame. Please follow the instruction below: Please make sure that the rear shock or its accessory parts do not touch the frame when mounting or suspending. For doing so release the air/remove the coil, install the shock and compress the shock completely. If the shock touches the frame while doing so, do not use this shock in order to avoid damage to frame, swingarm or shock FRONT FORK SET-UP/ CHANGE OF FRONT FORK For the set up of the front fork please use the fork specific manual attached to the bike. VOLTAGE FR 13 ENGLISH We recommend using front forks with distance of 525mm to 571mm between mid of axle to top of crown, as this will not influence the geometry and alter handling of the bike. PIVOT MAINTENANCE The pivots and bearings on SCOTT Voltage FR are extremely easy to maintain. An external treatment with a grease spray after every bike wash is all you have to do. [. . . ] In addition, you will find at the end of this manual a protocol for the handing over of the bike which will remain in copy at the SCOTT dealer after acceptance and signature of the consumer. It is obligatory to show this protocol of handing over together with the defective part in case of a warranty claim given that it provides evidence of purchase. [. . . ]