User manual SCOTT RXI 400 WL TECHNICAL SPECIFICATIONS

[. . . ] RXi 400WL Wi-Fi Internet / Ethernet/ FM PLL Radio Instruction Manual PRECAUTIONS Follow the advice below for safe and appropriate operations. Do not use the unit in places, which are extremely hot, cold, dusty, or humid. Do not restrict the airflow of the unit by placing it in a place with poor airflow, by covering it with a cloth, or by placing it on a carpet. When connecting and disconnecting the AC/DC adapter from the AC mains outlet, grip the plug and not the cord itself. [. . . ] "Settings" menu: Settings Descriptions Display Time Set the hour and minute of the clock time. "set / Set the alarm time and enable alarm enable": function. To search automatically, turn the SCROLL/SELECT /SNOOZE knob on the unit (or the UP or DOWN button on the remote control) and release to tune to a station. To search manually, press the SCROLL/SELECT/SNOOZE knob once to go to manual search mode and then turn it to search for a station. Achieve optimum reception When listening to a FM radio station, extend and position the FM antenna to achieve optimum reception. Preset FM radio stations You can store up to five preset stations for FM radio. Tune the radio to a desired station, then press and hold down the preset buttons P1 to P5 on the unit to store the station. Note: The press and hold button operation does not work on the remote control. Listen to a preset FM station Direct entry In FM radio mode, press one of the preset buttons P1 to P5 to listen to the preset station. Via the "Favorites" menu The preset stations are stored with the favorite stations in the "Favorites" menu. Select the following menus: "FM Radio" à "Favorites" and select the desired preset station. Press the SELECT button to confirm. GB- 9 INTERNET RADIO OPERATION Your unit can be connected to a wireless network (Wi-Fi) or an Ethernet. Note: Before operating this mode, make sure that you have read and understood the instructions in "PREREQUISITES FOR INTERNET RADIO" and "CONNECTIONS". Configurations setup Wired connection (Ethernet) 1. Connect the unit to the broadband Internet using an RJ45 Ethernet cable (not supplied). Select "Settings" à "System" à "Connection" à "Ethernet" à "DHCP" or "STATIC IP". Depending on your Internet connection type, select "DHCP" or "STATIC IP" to enable the unit to connect to the Internet. In "DHCP" mode, an IP address is automatically assigned to the unit. In "STATIC IP" mode, you must check with your service provider to obtain the correct IP data as follows: "IP address" à "IP mask" à "IP gateway" à "DNS" Wi-Fi connection 1. Use a router (not supplied) to connect the wireless access point (Wi-Fi) to the broadband Internet, refering to the "CONNECTIONS" section. Select "Settings" à "System" à "Connection" à "Wi-Fi". The unit will scan for all available wireless networks and display the network names (SSID). Select the correct encryption security system: Open network, WEP key or WPA. Note: After entering the WEP or WPA key, you need to select "DHCP" or "STATIC IP". Turn the SCROLL/SELECT/SNOOZE knob to adjust the number/ character and press it to confirm. [. . . ] (Waste Electrical and Electronic Equipment Directive) GB-13 TROUBLE SHOOTING GUIDE Problems 1. Does not connect to the Internet Recommendations FM Radio 1. 1 Extend and position the FM antenna to achieve the best reception. Internet Radio 2. 1 Ensure that you have configured your home network correctly by connecting to the Internet from a PC using the same network. 2. 2 For a wired connection (Ethernet), check that the Ethernet cable is properly plugged in. 2. 3 Ensure that a DHCP server is available or that you have configured a static IP address. [. . . ]