User manual SCOTSMAN SLE300

[. . . ] Optional Kits (for SLD150-1B) Include: Coin Mechanism, kit number KSLDC2 Key Mechanism, kit number KSLDK2 All kits are field installed. Top View of SLD150 Dimensions Basic (with legs) W Electrical xDxH SLD150S-1B 22" x 32" x 50" 115/60/1 Model Finish Ice Storage Capacity 90 lb. Max Fuse Size 15 Min Circuit Ampacity 2. 9 Stainless Steel October 1996 Page 2 SLD150 Installation: General After the carton has been removed from the dispenser, the legs may be installed. Place flat portions of the carton on the floor behind the dispenser and lay the dispenser down on its back. Move the dispenser to an upright position and set it in the location where it will be installed. [. . . ] After everything is operating, give key to user. Control Box Layout Control Relay Coin Mech Relay Electrical Shock Hazard. Remove the nuts that secure the push button cover to the dispenser and remove the cover. Remove the screws that hold the push button switch to the dispenser and remove the push button switch. Remove cover plate on right side of front panel, below push button switch; use 5/16" nut driver. Secure the coin mechanism to the mounting plate from the inside of the dispenser. Remove the timer mechanism from the kit and install it in the control box. Remove wires numbered 8 and 9 from the control box, they will be replaced by new wires from the kit marked 8 and 9. Place a quarter in the slide of the coin Adjustment Coin Mech Timer Agitation Timer Electrical Sequence 1. Timer closes internal contacts, connecting power to gearmotor (and door solenoid if -1B) 3. Gearmotor rotates dispense wheel until internal timer contacts (AND cam switch contacts if -1) open. The time of rotation (and amount of ice dispensed) is determined by the timer. October 1996 Page 5 SLD150 Key Kit Installation: (KSLDK2) 1. Place switch mounting bracket behind cover plate and over fitting, with the switch below the fitting. Using the locknut provided, fasten the fitting in place with the flats vertical. Place the cylinder in the brass fitting, and secure to the fitting with the set screw. [. . . ] Remove all of the ice stored inside the dispenser bin and shut off the ice maker. Disconnect electrical power Wash the entire bin area and the delivery area. Using the ice machine cleaning solution, clean the ice grill, sink, and water pan. [. . . ]