User manual SCOTSMAN RF33

[. . . ] This manual was printed on recycled paper. November 1992 Page 1 RF33 Specifications of RF33A-1WA: Capacity 3 + cubic feet Insulation 1" foamed in place polyurethane Compressor 1/ 16 H. P. Condenser Type Forced Draft Cabinet dimensions are critical to a built in installation. The diagrams illustrated below show the details of the cabinet construction. Note: Right and Left Placement of Machines Will Not Affect Performance. 2" 5. 1 cm 1/2" 1. 3 cm 29 7/8" 74. 0 cm 4"(10. 2 cm) to bottom of legs November 1992 Page 2 RF33 Installation: After the carton has been removed, check for any concealed damage. Open the door and remove all packing materials, including warranty packet, tape, and warranty registration. Wipe the interior of the cabinet with soap and water to remove any manufacturing or shipping residue. [. . . ] Open the door and remove the three screws holding the lower hinge to the cabinet. With the door open enough to see both screws at the top door hinge, remove the two screws. Remove the single screw and the hinge filler plate from the top of the door. Install the other filler plate (shipped inside refrigerator compartment) onto the top corner of the door where the hinge was. Remove the three plastic plugs from the top front corner where the hinge will mount. Remove the three plastic plugs from the lower front corner where that hinge will mount. Remove that hinge from the top and, flipping it upside down, install it onto the bottom of the door, on the opposite side using the original screws. Remove the hinge assembly from the bottom of the door, and flip it upside down; secure it to the cabinet at the opposite side top position with the original screws. Check operation of the door by opening and closing it. Hinge Door Handle Filler Plate Hinge Magnetic Gasket Door Reverse Hinges From Top to Bottom and Left to Right To Reverse Door Swing November 1992 Page 5 RF33 Installation The machine should not be installed in a room that falls below 50oF. Level the cabinet by turning the leveling legs at the base of the refrigerator. Do not slide into place until the unit has been started. Operation: To begin operation: Open the door, locate the temperature control knob in the upper right portion of the interior and rotate that knob clockwise until it is about at the mid position. The compressor and fan motor should both be operating, unless the refrigerator is below 35oF. That is the signal that the refrigerator is functioning and the cabinet may now be placed in its installed position. The refrigerator will require some time to cool the air and cabinet interior. If desired, a thermometer may be placed in the interior and the temperature checked. interior temperature. Temperature Control Location of Temperature Control Freezing Compartment Plastic Drip Tray Note: As warm products are placed in the refrigerator, the refrigerator will likely operate for some time to cool them. When the refrigerator is empty, it will switch on and off frequently because there's only air inside, and the temperature of the air changes quickly. The temperature of the Refrigerator may be adjusted by rotating the temperature control knob: Turn the knob clockwise for colder and counterclockwise for warmer. Placing ice trays in the freezing compartment will reduce refrigerating capacity. Use: The refrigerator is permanently lubricated, no oiling is required. [. . . ] A suction side port must be added to service the refrigeration system. Do not add a discharge side port, as the minimal charge will be affected by the added space. Note: prior models use an aluminum condenser with copper stubs, very careful heat sinks are required to braze at those connections. An example could be a flare block clamped over the aluminum tubing of the condenser. [. . . ]