User manual SCOTSMAN C2648R

[. . . ] Installation and User's Manual for Remote Condenser Modular Cuber Model C2648R C2648 Remote Condenser Models - User Manual Introduction The design of this modular remote cuber is the result of years of experience with remote ice machine refrigeration systems. Standard features of this product include front accessible on-off switches, always-visible indicator lights, mechanical assist ice harvest for extra efficiency, automatically adjusting water purge and a control system that optimizes system operation. This installation and user manual is divided into three sections: Installation, Use and Operation and Maintenance. The Installation section provides the trade person with the information needed to properly install and start up this ice system. [. . . ] Use rigid drain tubes and route them separately ­ do not Tee into the bin's drain. Install a new cartridge if the filters were used with a Vent the reservoir drain. of the drain, extended about 8 ­ 10" will allow the gravity drain to empty and also keep any surges Drains during draining from discharging water. All models require drain tubing to be attached to Horizontal runs of drain tubing need a ¼" per fall them. There is a single ¾" FPT drain fitting in the per foot of run for proper draining. Install new tubing when replacing a prior ice machine, as the tubing will have been sized for the old model and might not be correct for this one. Follow all applicable codes. Water Inlet Connection Potable Water Supply Reservoir Drain, Venting Required Optional Water Filters Floor Drain Water Supply and Drain Connections October 2010 Page 12 C2648 Remote Condenser Models - User Manual Electrical The machine is not supplied with a power cord, one Electrical connections are made inside the junction box in the back panel of the ice machine. Remove the junction box cover and route the power cord through the access hole and The dataplate on the back of the cabinet details the properly attach the power supply wires to the power requirements, including voltage, phase, leads in the junction box. Attach the remote condenser fan motor wires to the wires in the junction box tagged "fan a licensed electrician is recommended. Attach a ground wire to the ground connection Voltage variation must not exceed the limits listed in the junction box. A separate knockout hole has been provided near the ice maker electrical junction box. Return the junction box cover to its original position and secure with the original screws. Follow all applicable local, state and national codes. Remote Condenser Electrical Connection To Remote Condenser Fan Motor Install Strain Relief Junction Box Cover Ground Wire Connection Power Supply Wires Install Strain Relief Power Supply Electrical Connections October 2010 Page 13 C2648 Remote Condenser Models - User Manual Final Check List: 1. Has the interconnecting tubing been properly routed between the remote condenser and the ice machine?Has the power supply wire from the ice machine to the remote condenser been properly run and connected?Have all required kits and adapters been properly installed? October 2010 Page 14 C2648 Remote Condenser Models - User Manual Initial Start Up 1. Note location of control board in upper left corner of the machine's front. Observe that some of the control's indicator lights glow and its display shows O. Wait 4 hours for the compressor's crankcase heater to warm up the oil in the compressor. Determine the water purge setting from the close and the water pumps will stop. The hot setting to accommodate the local water gas valves and harvest assist devices will activate conditions. and the liquid line solenoid valve will open, then the compressor, remote fan motor and water pumps 10. seconds later the hot gas valves will close and the harvest assist devices will return to their standby 11. [. . . ] Push and release the green ON button to resume ice making. Remove and discard all ice. Clean Storage Bin Mix a solution of Scotsman Nickel Safe ice machine cleaner and wash all interior surfaces of the ice storage bin to remove any mineral scale build up. Mix a solution of sanitizer and thoroughly wash all interior surfaces of the ice storage bin. If the machine has been connected to water filters, check the cartridges for the date they were replaced or for the pressure on the gauge. [. . . ]