User manual SANGEAN PT-80

[. . . ] Switches the clock between local time 1 and local time 2, for example summer and winter time. Lights up red when searching for an SSB (Single Side Band) station on short wave. The signal alarm function is activated The key lock is activated The sleep timer is activated A stereo FM station is being received Displays the SW (short wave) waveband Displays the FM (VHF) waveband Displays the MW (medium wave) waveband Displays the LW (long wave) waveband Displays the first half of the day in 12-hour format Displays the second half of the day in 12-hour format Display memory levels 1 and 2 Preset position displays Flashes when the batteries are low Frequency display for MW, LW and SW Frequency display for FM SW frequency band display Displays the increments in which the frequency is changed 1 2 Open the battery compartment on the back of the device by pressing the marking and opening the lid. Each time you switch off the radio, the battery charge indicator, for example »3«, appears for seven seconds. [. . . ] 1 2 Save short wave stations in the same way as described in the previous section. Once you have stored nine stations on one memory level » M 1 «, press »SW PAGE CLOCK 1/2« to switch to the second memory level. Note: If you try to store more than 18 stations and press »MEMO AM/PM«, »FULL« appears in the display. This function allows you to automatically search for and store nine stations in each of the FM, MW and LW bands (not SW). 1 To start the search, press » « and » « at the same time and hold them down until you hear a signal. ­ The search starts at the lowest frequency in the selected wave band, and stores the nine stations with the strongest signals. After the search has finished, a signal sounds and the last station stored can be heard. ­ Display: » M 1 « and the preset number, for example » «. Notes: When you start the search, all the previously stored stations are deleted. You can stop the search by pressing »ON/OFF«. You can reorganise the preset stations using MODE 50 or 51 (see page 16). ­ Display: the frequency and the preset number, for example » Press »MEMO AM/PM«. Note: If the radio is switched off, press »DISPLAY« to switch the display to the clock, and start at step 1. ­ Display: the alarm time you entered, » « or » « stay lit. If you select short wave, you can select the frequency band by pressing »SW SELECT«. ­ Display: the frequency and the preset number, for example » «. To call up preset numbers 10 to 18 in the SW band, press »SW PAGE CLOCK 1/2« to switch to the second memory level. Notes: For FM reception pull out the telescopic antenna and tilt it until you receive the best signal. You can call up all the stored radio stations in a wave band automatically for seven seconds (memory scan). ­ The device starts with the current preset station and soon changes to the next one. ­ When you reach the station you want, press »0 M. Enter the new preset position using the numerical buttons » 1 . [. . . ] To permanently change from local time 2 to local time 1, press »SW PAGE CLOCK 1/2« and then » FREQ. Using the »MODE« button and a two-digit code, which you enter using the numerical keys »0 . 9«, you can change various functions: Code Function MODE MODE MODE MODE MODE 10 20 30 40 50 Code Function FM frequency change in 200 kHz steps MW frequency change in 10 kHz steps Time display in 24 hour format Signal tone on Arrange stations in sequence from low to high frequency range FM frequency change 11 in 100 kHz steps MW frequency change 21 in 9 kHz steps Time display in 12 hour format Signal tone off Arrange stations in sequence from low to high frequency range 31 41 51 This is how to change the various function modes: 1 2 3 Press »MODE«. Enter the code, for example »40«, using »0 . [. . . ]